Gamma 5003 Owner's Manual

Also see for 5003: Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Gamma 5003 Owner's Manual Manual pdf 12 page image

12STRINGING THE FRAMEWeaving the Cross StringsWeave the cross strings over and under themain strings being careful to alternate theweave direction of each consecutive crossstring so as to be opposite of the previouslyinstalled cross string.Once the final cross string is tensioned andclamped, tie off at the appropriate hole speci-fied by the racquet manufacturer. Remove theframe from the mounting system by looseningthe shoulder supports and frame supports.Locking the TurntableThe turntable may be locked in any position.The turntable winged lock knob is packedseparately. Install the lock knob into thethreaded hole located on the side of thetensioner bar post.Rotate the knob clockwise to lock the turn-table, and counter-clockwise to release theturntable.ADDITIONAL FEATURESPulling TensionWrap the loose section of string once aroundthe roller guide and insert the string betweenthe diamond dust coated string gripper plates.Pull the string perpendicular to the gripperplates while slowly rotating the tensionercrank clockwise until the brake lever popsout of the latching block. The string is nowtensioned and can be clamped in place withthe remaining fixed clamp.Repeat the above steps until all main stringsare installed. Tie off ends of main strings asper racquet manufacturers recommenda-tions.