Q.seriesGantner Instruments Test & Measurement GmbH 815 Configuration → Q.gate settingstion names, etc. The following sections only deal with the mostimportant settings; for further information read the appropriateTest Controller manual.Mark the Test Controller to be set and select Settings from thecontext menu or double click on the Test Controller to start theconfiguration program. Then you can carry out all the modulesettings in the window of this program. A tree structure similar tothat in Windows Explorer shows the individual parameter groups.Open up the entries as required by a click on .Fig. 5-5 Configuration dialog for a Q.gate. Test Controller5.8.1 Slave interfaceUsing this parameter group, the speed of data transmission onthe individual interfaces (UARTs) can be defined. Since all mod-ules are brought together in one housing with Q.brixx, here themaximum possible baud rate of 48 MBd can be used.A change in the baud rate is carried out automatically on all con-nected modules.Watchdog Timeout: With a value > 0 the module error LED isactivated if there is a lack of communication after this period.Answer Delay: This parameter is only needed when the modulesare not directly connected to this interface, but instead con-nected to a modem, for example. Then enter the time here whichis to be awaited additionally due to the slow connection.5.8.2 Host interfaceThis parameter group defines the settings for communicationwith the host(s) (PC, PLC, etc.).
