Ganz C-AllView Installer's Manual

Also see for C-AllView: Installation manual

Contents

Ganz C-AllView Installer's Manual Manual pdf 8 page image

Camera telemetry settingsDepending on the chosen protocol, telemetry control signals may be fed to thecamera either via the primary co-axial video link cable or through the twisted paircables that are included within the composite cable.Note: Due to limitations or software changes within some protocols, it is not alwayspossible to implement all of the camera’s features.All settings related to telemetry control are configured using two banks of switches(S1 and S2) located behind a removable panel within the hub of the camera.To access the switches, remove the two retaining screws and remove the panel:Note: In all switch setting tables, a dash (-) means the corresponding switch is Off.Device ID address (block S1, switches 1 to 8)For protocols which use RS485 control signals via the twisted pair link within thecamera’s composite cable, you can determine the device ID address for the camera.Note: These settings are ignored for protocols that use the primary video coaxialcable to transfer telemetry signals.Device ID S1-1 S1-2 S1-3 S1-4 S1-5 S1-6 S1-7 S1-80 - - - - - - - -1 On - - - - - - -2 - On - - - - - -3 On On - - - - - -4 - - On - - - - -5 On - On - - - - -6 - On On - - - - -7 On On On - - - - -8 - - - On - - - -9 On - - On - - - -10 - On - On - - - -11 On On - On - - - -12 - - On On - - - -13 On - On On - - - -14 - On On On - - - -87654321876543218765432187654321S2S1