Ganz ZC-PT Series Installation Manual

Also see for ZC-PT series: Installation guide User manual Installation guide User manual User manual

Ganz ZC-PT Series Installation Manual Manual pdf 33 page image

Installation Guide324.4.2 Standard Pendent MountItems Needed:• Dome Camera• Outdoor Mount Kit (supplied)• Data Cable (supplied)• Ethernet Cable (IP Dome Camera)• Standard Pendent Mount and equipped items (optional accessory)• Waterproof Rubber (supplied)• M5 Standard/Security Screw (supplied)• Screws and Screw Anchors for fixing the Standard Pendent Mount ontothe ceiling (not supplied)Tools Needed:• Tool for drilling• Tool for screwingFollow the steps below to mount the Dome Camera with the StandardPendent Mount.1) Make a cable entry hole on the wall to recess the cables. Otherwise, userscould push up the cable entry board on the Standard Pendent Mount’smounting plate to place the cables (see the illustration in section 4.4.1Compact Pendent Mount > Step 1).2) Fix the Standard Pendent Mount on the wall with proper screws and screwanchors.3) Attach the Waterproof Rubber to the Standard Pendent Mount.4) Run the cable(s) through the Standard Pendent Mount with the DataCable’s 22-pin cable coming out of the outlet.NOTE: Please block the cable entry hole with the supplied spongeto avoid insects entering the Pendent Mount. See the illustrationsin section 4.4.1 Compact Pendent Mount > Step 4.5) Thread the cable(s) through the Outdoor Mount Kit and join the OutdoorMount Kit to the Standard Pendent Mount with the supplied screws andwashers. Then adjust the Waterproof Rubber to the joint.6) Connect the cable(s) to the Dome Camera.7) Join the Dome Camera to the Outdoor Mount Kit with the supplied M5screw and washers.