Part # 4520898 (03/31/11)Page 24Fault Possible Cause Action To Take By Operator Or OperatingPersonnelNo heatingOperation indicator lightis OFF (dark)No mains supply Check the electrical supply (cable pluggedonto the wall socket)Check preliminary fusesControl knob is in OFF-position Turn control knob ONCooker is defective Ask your supplier for repair serviceUnplug the cooker from the mains supplyNo heatingOperation indicatorlight is flashing (If anerror code is flashing seesection “Malfunction witherror code”)Pan is too small (bottom diameter less than4.72” (120mm), only BH/IN and SH/IN)Use a suitable panPan is not placed in the center of the heatingarea (the cooker cannot detect the pan)Move the pan to the center of the heating areaUnsuitable pan Choose a pan recommended for inductioncooking 1Cooker defective Ask your supplier for repair service, unplug thecooker from the mains supplyPoor heatingOperation indicator lightis ON (shining)Used pan is not appropriate Use a pan recommended for induction cookingand compare the result with “your” panAir-cooling system obstructed Verify that air inlet and air outlet are notobstructed with objectsAmbient temperature is too high (the coolingsystem is not able to keep the cooker in normaloperating conditions 2)Verify that no hot air is sucked in by the fan.Reduce the ambient temperature. The air inlettemperature must be lower than 104°F /40°C.One phase is missing (only units with threephase supply)Check preliminary fusesCooker defective Ask your supplier for repair service, unplug thecooker from the electrical supplyNo reaction to controlknob positionsControl knob defective Ask your supplier for repair serviced, unplugthe cooker from the mains supplyHeating cycle switches offand onWithin minutes, fan isactiveAir inlet or outlet obstructed or fan dirty Remove objects from air inlet and air outletslots, clean the slotsClean fanHeating cycle switches offand onWithin minutes, fan isnever activeFan defectiveFan control defectiveAsk your supplier for repair service1 To verify, if the pan is suitable, use a permanent magnet and find out if it sticks on the bottom of the pan. If not, your panis not suitable for induction cooking. Choose a pan which is recommended for induction cooking. Choose pan materialsuitable for induction appliances.2 The cooling-system (fan) starts to operate when the ambient temperature in the control area exceeds 131°F/55°C. Atheat temperatures higher than 158°F /70°C the controller automatically reduces the power to keep the unit in normaloperating conditions. The cooker runs in a non continuous mode. This mode can be heard.TROUBLESHOOTING continuedMalfunction Without Error Code