Part # 9229077 (07/05)Page 0SERVICE AND PARTSInstallation, maintenance and repairs should be performedby your local authorized Garland service agency listedin your information manual pamphlet.2. With the grates removed, turn over all the briquetteson the ceramic coal model.3. Remove the perforated screen, drip pan, and greasecan and clean thoroughly.Daily-GXR Series. Remove the broiler grates. Wire brush them cleanof any encrusted materials and wash in hot, soapywater. A common cleaning practice is to turn gratesupside-down to burn off encrusted material. Donot do this with the radian char-broiler! The flamefrom the burner is shielded by a cast iron radiant,with the result that heat not flame reaches the grate.If is likely that cooked-on-matter will cook in evendeeper rather than burn off.2. Remove the radiants and wire brush them clean,then wash in hot soapy water. A rule of thumb isthat if the grates are becoming encrusted, so are theradiants.3. The Garland Char-Broiler uses a double drip tray.The front grease trough (at the top of the unit)downspouts to a 3-5/8” tray running the width ofthe body; remaining grease which drips past theradiants is connected by a second pan coveringthe reminder of the broiler bottom. The front traymust be checked frequently during operation anddrained as necessary; the rear drip pan should alsobe checked occasionally. Spills should be wiped asthey occur and, at the end of the day, both pansshould be washed in hot, soapy water.PeriodicYour Garland Char-Broiler should be checked andadjusted periodically by qualified service personnel aspart of a regular kitchen maintenance program.Cleaning Stainless SteelAll stainless steel body parts should be wiped regularlywith hot, soapy water during the day, and with a liquidcleaner designed for this material at the end of eachday. Do not use steel wool, abrasive cloths, cleaners,or powders! If it is necessary to scrape stainless steelto remove encrusted materials, soak the encrusted areawith wet cloths to loosen the material, then use a woodor nylon scraper. Do not use a metal knife, spatula, orany other metal tools to scrape stainless steel. Scratchesare almost impossible to remove.CLEANING AND MAINTENANCE ContinuedGarland/U.S. Range products are not approved orauthorized for home or residential use, but are intendedfor commercial applications only. Garland / U.S. Rangewill not provide service, warranty, maintenance or supportof any kind other than in commercial applications.