Garland HEEG “CL” Installation And Operation Manual

Contents

Garland HEEG “CL” Installation And Operation Manual Manual pdf 8 page image

Part # 4526671 (10/02/09)Page 8INSTALLATION ContinuedFurther, if the unit is to be installed on a non-combustiblesurface that is equipped with casters, means must beprovided to limit the movement of the unit with castersFinal Gas Connection ReviewCheck all gas connections for leaks using a soapy solutionbefore lighting any pilots! DO NOT USE AN OPEN FLAMETO CHECK FOR LEAKS! Putting an open flame beside a newconnection is not only dangerous, but will often miss smallleaks that a soapy solution would findAll Garland appliances are adjusted and tested beforeleaving the factory, effectively matching them to sealevel conditions Adjustments and calibrations to assureproper operation may be necessary on installation to meetlocal conditions, low gas pressure, differences in altitude,variations in gas characteristics, to correct possible problemscaused by rough handling or vibration during shipment, andare to be performed only by qualified service personnelThese adjustments are the responsibility of the customer,installer and/or dealer and are not covered by the GarlandwarrantyAll burners are equipped with continuous electronic sparkelectrodes to insure flame is on at all times during operationContinuous sparking is intended to remain energized untilpower is manually switched offWARNING: All connections must be sealed with a jointcompound suitable for LP gas, and all connections must betested with a soapy solution before lighting any pilots!Start UpBefore initial lighting or if unit does not operate at all checkto see if:1 Main gas supply shut off to appliance is open2 Electric power supply power and cord Nema 5-15P hasbeen plug into an appropriate 120V 15Amp 60Hz outletFor daily start up:1 Models HEEG-24CL and HEEG-36CL have one powerswitch Once pushed to the “ON” position an ignitersupplies a continuous spark to the burners igniting thegas to all burners simultaneously At the same time thepower switch opens up the gas flow to burners2 Models HEEG-48CL and HEEG-60CL have two powerswitches which operate in the same manner as thesingle switch above Each switch operates separatelyallowing the operator to run two sections of the broilerindependently On the HEEG-48CL the switch on the farleft operates burners 1 to 5 The power switch on theright will operate burners 6 to 9 On the HEEG-60CL theleft switch controls burners 1 to 6 and the right switchcontrols burners 7 to 113 If burners do not ignite, shutdown power to the unit,and wait 5 minutes before repeating ignition If repeatedignition fails, shutdown power to the unit and contact aservice personShut Down1 For shutting down overnight, on all models turn thepower switch(es) to the “OFF” position2 When shutting down for longer periods, turn the powerswitch(es) to the “OFF” position and turn the manualsupply shut off valve to the “OFF” positionFinal PreparationNew units are wiped clean with solvent at the factory toremove any visible signs of dirt, oil, grease, etc , remainingfrom the manufacturing process They should be washedwith hot, soapy water to remove any solvent or oil residue orinstallation dust or debris before using for food preparation