Garland M series Operation Manual

Also see for Master MST42R: Installation, operating & service manual

Contents

Garland M series Operation Manual Manual pdf 14 page image

Part # 1382680 Rev 3 (05/10/11)Page 14OPERATION Continued2. Holding the oven gas valve fully in, depress the red piezoignitor button located behind the lower drop downpanel.3. When the pilot is lit, continue to hold the oven gas valvefully in for 20 seconds, then release it. If the pilot goes out,wait for 5 minutes then repeat from step 1.4. When the pilot is established, push the gas valve in againand turn it anti-clockwise to the full on position, then setthe thermostat to the desired temperature.Start Up1. Activate the power switch to “cook” position.2. Turn oven gas valve to the on.3. Turn the thermostat to desired setting.Cool Down1. Turn thermostat and oven valve off.2. Open door.3. Activate power to the cool down position.Shut Down1. Turn thermostat off.2. Return power switch to “OFF” position.3. Turn oven valve off.The motor on your range convection oven is maintenancefree since it is constructed with self lubricating sealed ballbearings. It is designed to provide durable service whentreated with ordinary care. We have a few suggestions tofollow on the care of your motor.A. When the motor is operating, it cools itself internally byair entering the rear of the motor case, provided properclearance has been allowed.B. Since the blower wheel is in the oven cavity it is at thesame temperature as the oven. If the motor is stoppedwhile the oven is hot, the heat from the blower wheel isconducted down the shaft and into the armature of themotor. This action could shorten motor life.C. We recommend, at the end of the bake or roastingperiod, when the oven will be idle for any period of timeor before shutting down completely, that the doorsbe left open, and by use of the cool-down position onthe fan switch, the fan continues to run for at least 20minutes.Note: The convection oven motor should never be turned“OFF” during cooking or when the oven is “HOT”Char-Broiler (M,MS Models)Lighting1. Raise or remove the cooking grates. Every group of two(2) burners has one pilot located centrally between them.2. Depress the piezo ignitor button to light pilots. The pilotburner should be adjusted to provide for rapid ignitionon the burner.3. Turn burner valve on by rotating the know anti-clockwise.A sharp blue flame should be approximately 1/4” high.Shut Down1. Turn all valves to the “OFF” position “ by rotating the knobclockwise 1/4 turn.2. If the unit is to be shut down for an extended period oftime, close the inline gas valve.Char-Broiler (MST Models)Lighting1. Raise or remove the cooking grates. Every group of two(2) burners has one pilot located centrally between them.2. Push in the gas valve and turn it anti-clockwise to theignition position.3. Holding the gas valve fully in, depress the red piezoignitor button located behind the lower door panel.4. When the pilot is lit, continue to hold the gas valve fully infor 20 seconds, then release it. If the pilot goes out, wait for(5) minutes then repeat from step 1.5. When pilot is established, push the gas valve in again andturn it anti-clockwise to the full on position, then set thethermostat to the desired temperature.