Garland M60XR Installation And Operation Manual

Also see for M100XR: Installation, operation and maintenance manual

Contents

Garland M60XR Installation And Operation Manual Manual pdf 5 page image

Part # 4515576 Rev 1 (01/21/10) Page 5GENERAL INFORMATION1. Check crate for possible damage sustained during transit.Carefully remove unit from crate and again check fordamage. Any damage to the appliance must be reportedto the carrier immediately.2. The wires for retaining the burners and other packingmaterial must be removed from units. Any protectivematerial covering stainless steel parts must also beremoved.3. All equipment is shipped from the factory with legsfitted, unless otherwise specified. Where the range is tobe mounted on a dais or cove base, it is shipped withoutlegs. Legs must be fitted to the oven where it is installedon a combustible floor.4. The type of gas and supply pressure that the equipmentwas set-up for at the factory is noted on the data plateand on the packaging. This type of gas supply must beused.5. Garland/U.S. Range products are not approved orauthorized for home or residential use, but are intendedfor commercial applications only. Garland / U.S. Rangewill not provide service, warranty, maintenanceor support of any kind other than in commercialapplications.6. Do not remove permanently affixed labels, warnings ordata plates from the appliance, for this may invalidate themanufacturer’s warranty.STATUTORY REGULATIONSThe installation of this appliance must be carried out bya competent person and in accordance with the relevantregulations, codes of practice and the related publications ofthe country and destination.The installation must conform to the National Fuel Gas CodeANSI Z223.1-latest edition, NFPA No. 54 – latest edition andNational Electrical Code ANSI/NFPA 70-latest edition and/orlocal code to assure safe and efficient operation. In Canada,the installation must comply with CSA B149.1 and localcodes where applicable.In Canada, electrical connections must comply withapplicable sections of the Canadian Electrical Code, C22.1 -latest edition.