Garland MWE3W Installation And Operation Manual

Also see for MWE3S: STEPS FOR PROGRAMMING GRILL RECOVERY CLEANING Programming instructions Programming Instruction Installation and operation manual Service manual

PART #4521777 (08/18/09)GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION INSTALLATION/OPERATION MANUALPage 27CONTROL PROGRAMMINGProgramming Modes; System SetupTo Change the Temperature Display Units(Fahrenheit / Celcius)The temperature display units (F or C) will changethe way a temperature is displayed on the controller(F – Fahrenheit, C – Celcius)1. With the controller display ON and either displayingthe current menu item or displaying “OFF”, PRESS andHOLD the button for approximately 3 seconds.Controller will display previously selected menu itemand its corresponding item number OR “Standby /Menu Item”.2. PRESS the AND arrow buttons TOGETHER.“CONFIGURE” will appear in the display.3. PRESS the arrow button. “Setup” will appear in thedisplay4. PRESS the button. “Temperature Unit” will appear inthe display.5. PRESS the button. The currently set temperatureunit will flash.6. PRESS the OR arrow buttons to change theflashing temperature unit.7. PRESS the button to save the new setting.8. PRESS THE 2X to exit the program mode.To Change the Time Display UnitsChanging the Time Display Units will change the waytiming cycles are displayed on the controller.1. With the controller display ON and either displayingthe current menu item or displaying “OFF”, PRESS andHOLD the button for approximately 3 seconds.Controller will display previously selected menu itemand its corresponding item number OR “Standby /Menu Item”.2. PRESS the AND arrow buttons TOGETHER.“CONFIGURE” will appear in the display.3. PRESS the arrow button. “Setup” will appear in thedisplay.4. PRESS the button. “Temperature Unit” will appear inthe display.5. PRESS the 1X. “Time Unit” will appear in the display.6. PRESS the button. The current time unit will flash.7. PRESS the OR arrow buttons to change theflashing time unit.For a complete listing of setup functions and theiroptions, see page .8. PRESS the button to save the new setting9. PRESS THE 2X to exit the program mode.To change the Key Chirp (Yes / No)Changing the Key Chirp On or Off will either turn on or offthe sound of the controller when a button is pressed.1. With the controller display ON and either displayingthe current menu item or displaying “OFF”, PRESS andHOLD the button for approximately 3 seconds.Controller will display previously selected menu itemand its corresponding item number OR “Standby /Menu Item”.2. PRESS the AND arrow buttons TOGETHER.“CONFIGURE” will appear in the display.3. PRESS the arrow button. “Setup” will appear in thedisplay4. PRESS the button. “Temperature Unit” will appear inthe display.5. PRESS the repeatedly until “Key Chirp” appears in thedisplay.6. PRESS the button. The currently set Key Chirp willflash.7. PRESS the OR arrow buttons to change theflashing “YES” or “NO”8. PRESS the button to save the new setting.9. PRESS THE 2X to exit the program mode.To change the AudibleChanging the Audible Sound will change the way thecontroller sounds when a timing cycle has completed itscountdown.1. With the controller display ON and either displayingthe current menu item or displaying “OFF”, PRESS andHOLD the button for approximately 3 seconds.Controller will display previously selected menu itemand its corresponding item number OR “Standby /Menu Item”.