Garland XG24-JIB Service Manual

Contents

Part # JIBSM08 Rev 7 (08/04/09)Page 28To View the Flash Number:1. Press and hold for three, (3) seconds. “ENTER CODE” isdisplayed.2. Using the Product buttons, 0-9 enter the code, (1251).“ENTER CODE **** ” is displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” is displayed.4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”5. Press four, (4), times to view the Flash Number. “FLASHNUMBER X…X” is displayed. (Flash number varies by grill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.To View the Software Number:1. Press and hold for three, (3) seconds. “ENTER CODE” isdisplayed.2. Using the Product buttons, 0-9 enter the code, (1251).“ENTER CODE **** ” is displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” is displayed.4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”5. Press five, (5), times to view the Software Number.“SOFTWARE NUMBER X…X” is displayed. (number variesby grill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.To View the Download Number:1. Press and hold for three, (3) seconds. “ENTER CODE” isdisplayed.2. Using the Product buttons, 0-9 enter the code, (1251).“ENTER CODE **** ” is displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” is displayed.4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”PROGRAMMING continued5. Press six, (6), times to view the Download Number.“DOWNLOAD NUMBER X…X” is displayed. (Downloadnumber varies by grill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.System SetupTo Change temperature Units, (°F or °C):1. Press and hold for three, (3) seconds. “ENTER CODE” isdisplayed.2. Using the Product buttons, 0-9 enter the code, (1251).“ENTER CODE **** ” is displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” is displayed.4. Press two, (2) times. “PROGRAMMING MODE SYSTEMSETUP” is displayed.5. Press to enter system setup. “TEMP DISPLAYFAHRENHEIT (or CELSIUS)” is displayed.6. Press to change the temperature units to eitherFahrenheit or Celsius.7. Press to save the changes.8. Press to return to “PROGRAMMING MODE SYSTEMSETUP”9. Press again to exit.To Change Gap Setting Display Units:1. Press and hold for three, (3) seconds. “ENTER CODE” isdisplayed.2. Using the Product buttons, 0-9 enter the code, (1251).“ENTER CODE **** ” is displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” is displayed.4. Press two, (2) times. “PROGRAMMING MODE SYSTEMSETUP” is displayed.5. Press two, (2), times. “GAP SETTING DISPLAY INCHES(or MILLIMETERS)” is displayed.6. Press to change the Gap Setting Display units to eitherInches or Millimeters.7. Press to save the changes.