Appendix64Attaching the Vehicle Adapter to the StreetPilot 2610/2650Your vehicle adapter is a 12/24 volt DC adapter with an external speaker system. This adapter is yourStreetPilot’s power source when you are in a vehicle (the StreetPilot does not use batteries). Use the ACadapter (included) when using the StreetPilot indoors.1. Locate the power connector on the rear of the StreetPilot. The connector is “keyed” with a notch locatedtowards the bottom of the plug.2. Mate the power plug on the vehicle adapter to this connector by aligning the notches and sliding theplug into the connector until fully seated, as shown below.3. Plug the cigarette lighter portion of the vehicle adapter into an available cigarette lighter receptacle inyour vehicle. Use care when routing the adapter cable to ensure that it does not interfere with vehicleoperation in any way.Vehicle InstallationThe vehicle adapter comes with an external speakersystem that enables you to hear directions from yourStreetPilot.Periodically, you may need to change the fusethat’s located at the tip of the vehicle adapter.Simply unscrew the black, round end piece andremove/replace the fuse.A 3AGC/3AG 1 ampfuse is located atthe tip of the vehicleadapter Attach the vehicle adapter to the back of yourStreetPilot as shown above.
