Appendix68Removing and Installing the CompactFlash® (CF) Storage CardThe StreetPilot 2610/2650 supports Type I and II CompactFlash® (CF) storage cards. The top of the cardshould always face towards the FRONT of the unit when inserting. Type I cards have a slight ridge on thebottom of the card that aids with removal. When removing Type II cards, avoid pinching the card in themiddle; instead, grab the card by the top and bottom edges.To install a CF data card:1. Slide UP on the top portion of the CF card door, then open the door away from the unit.2. Insert the CompactFlash card into the slot with the top facing toward the front of the StreetPilot. Gentlypush the card in until the eject button extends out to about the end of the CF card. Do not applyexcessive force as this may damage the CF card and/or result in internal damage to theunit! When properly inserted, the CF card protrudes slightly from the slot (not flush).3. Close the card door by pushing the top of the card door towards the unit until it clicks and locks. Alwaysclose the door completely to prevent water entry.4. To remove the card, repeat step one, then push the eject button until it is flush with the casing. Gentlyslide the CF card out of the unit.Appendix D: CompactFlash®Data CardsOpeningthe CF CardDoor12Installing the CF Card Eject ButtonRemoving the CF CardCompactFlash® cards are widely available andyou can purchase additional cards at many differentretailers. Because Garmin does not manufacture thesecards, it is possible that CompactFlash cards by certainmanufacturers may generate radio frequency signalsthat interfere with the operation of your StreetPilot.These circumstances are beyond Garmin’s control.If this occurs, please use a CF card from a differentmanufacturer.TopTopType I CF CardType II CF CardRidge