Renaming a user waypoint.User waypoint list showing the current active-towaypoint and a proximity waypoint.SECTION3WPT KEYUser WaypointListThe third page available from the GNC 300XL’s W key is the user waypointlist, which can be used to quickly scan, review, rename or delete user waypoints.To display the user waypoint list:1. Press W and use O to display the user waypoint list.2. To scroll through the list, rotate K.The total number of user waypoints is displayed at the top of the page, with theindividual user waypoints listed two at a time in alphabetical order below. The arrowprompt, located at the top left of the page, will indicate which direction to scroll toview additional waypoints. The status of each waypoint will be displayed to the rightof the identifier when it is the active-to waypoint, part of an active or stored route ora proximity waypoint. To edit, rename or delete waypoints, the cursor must highlightthe desired waypoint.To highlight a waypoint:1. Press C twice and use O to highlight the desired waypoint.To edit a highlighted waypoint’s position:1. Press E to obtain the waypoint position page. Edit the waypoint position as described onpage 49. (Note: The active-to waypoint cannot be edited.)To delete a waypoint from the list:1. Highlight the desired waypoint and press \. Press E to confirm the deletion.To rename a waypoint from the list:1. Highlight the desired waypoint. Use K and O to enter a newidentifier for the waypoint.2. Press E on the confirmation page to change the name, or press \ to cancel. 53