Garmin 45 Owner's Manual

Also see for Drivesmart 55: Declaration of conformity Owner's manual Owner's manual Owner's manual

Contents

Garmin 45 Owner's Manual Manual pdf 10 page image

1 Rotate the end piece À counter clockwise to unlock it.TIP: You may need to use a coin to remove the end piece.2 Remove the end piece, the silver tip Á, and the fuse Â.3 Insert a new fast-blow fuse that has the same current, suchas 1 A or 2 A.4 Place the silver tip in the end piece.5 Push in the end piece and rotate it clockwise to lock it backinto the vehicle power cable Ã.Parked Video RecordingThe parked video recording feature enables automatic videorecording when the vehicle ignition switch is turned off. Thecamera starts recording when the camera sensor detectsmotion.NOTE: The parked video recording feature is only accessiblewhen the camera is connected to the Dash Cam parking modecable accessory. Go to buy.garmin.com to purchaseaccessories.Turning Parked Recording On or OffBefore you can record parked videos, you must connect yourcamera to the Dash Cam parking mode cable accessory(Parking Mode Cable Wiring Diagram, page 6).Select > Settings > Camera > Record While Parked.Recording Parked VideosBefore you can record parked videos, you must connect yourcamera to the the Dash Cam parking mode cable accessory(Parking Mode Cable Wiring Diagram, page 6).Turn off your vehicle.The camera enters parked recording mode and automaticallyrecords parked videos when the camera sensor detectsmotion.Parking Mode Cable Wiring DiagramItem Wire Color Wire FunctionÀ Black GroundÁ Yellow Battery 12 VÂ Red Accessory 12 VConnecting the Parking Mode Cable Accessory toPowerCAUTIONGarmin strongly recommends having an experienced installerwith the proper knowledge of electrical systems install thedevice. Incorrectly wiring the power cable can result in damageto the vehicle or the battery and can cause bodily injury.1 Route the parking mode cable accessory to a location in thevehicle with constant power, switched power, and a groundconnection.2 Connect the BATT wire to a constant power source.3 Connect the ACC wire to a switched power source.4 Connect the GND wire to the bare metal of the vehicle'schassis using an existing bolt or screw.5 Plug the parking mode cable accessory into the USB port onthe camera.TroubleshootingMy camera feels warm while it is operatingIt is normal for the camera to feel warm during typical use,especially while it is recording high-resolution video ortransmitting a Wi‑Fi signal.6 Troubleshooting

/ 12

Related manuals for Garmin Drivesmart 55