Garmin 45 Owner's Manual

Also see for Drivesmart 55: Declaration of conformity Owner's manual Owner's manual Owner's manual

Contents

Garmin 45 Owner's Manual Manual pdf 5 page image

Getting StartedWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.Installing the Memory CardThe camera requires a microSD™ or microSDHC memory cardof up to 64GB with a speed rating of class 10 or higher. You canuse the included memory card, or you can purchase acompatible replacement memory card from an electronicssupplier.1 Insert the memory card À into the slot Á.2 Press it in until it clicks.Removing the Memory CardNOTICERemoving the memory card while the device is turned on canresult in a loss of data or damage to the device.1 Turn off the device.2 Press the card in until it clicks.3 Release the card.The card ejects from the slot.Device OverviewÀ Press to turn the device on.Hold for 3 seconds to turn the device off.Select to return to the previous page.Á Select to scroll through menus or pages.Â Select to scroll through menus or pages.Ã From the viewfinder, select to save a photo.Hold to save a video clip.Select to choose an option in a menu.Installing the Mount onto Your WindshieldNOTICEThe adhesive mount is extremely difficult to remove after it isinstalled. You should carefully consider the mounting locationbefore you install the mount.Before you can install the adhesive mount onto your windshield,the ambient temperature must be from 21° to 38°C (from 70° to100°F).TIP: You can connect the device to power and hold the device inthe preferred mounting location to check the camera's field ofview at that location.1 Clean the windshield using water or alcohol, and a lint-freecloth.The windshield must be free of dust, wax, oils, or coatings.2 Remove the protective film from the mount adhesive.3 Position the mount over the mounting location.TIP: The adhesive is extremely sticky. Do not touch theadhesive to the windshield until the mount is properlypositioned and aligned.4 Press the mount firmly onto the windshield, and maintainpressure for 30 seconds.5 Pull the camera and mount away from the windshield.The metal disc remains attached to the windshield.6 Using your finger, press firmly on the disc for 30 seconds.This helps to ensure the disc adhesive has proper contactwith the windshield.7 Wait 24 hours before installing the Dash Cam.It takes 24 hours for the adhesive to bond properly to thewindshield.Installing and Setting Up the Dash CamNOTICEBefore installing the Dash Cam, you must install the mount andallow the adhesive to bond to the windshield for 24 hours.Failure to allow adequate bonding time may cause the mount todetach from the windshield, which could result in damage to theproduct or mount.1 Place the camera and mount onto the metal disc.2 Plug the vehicle power cable into the USB port on the device.Getting Started 1