Garmin AQUAMAP 10x2 Series Installation Instructions Manual

Also see for AQUAMAP 10x2 Series: Owner's manual Owner's manual Installation instructions

Contents

Garmin AQUAMAP 10x2 Series Installation Instructions Manual Manual pdf 3 page image

AQUAMAP™ 10x2/12x2 SERIES 3Dimensions and Ports (AQUAMAP 10x2 Series)316.8 mm185.2 mm68.5 mm123 4 56 789Item Usage1 8-pin XDCR2 LAN3 Power4 Ground5 Video CVBS input - BNC6 GPS antenna - BNC7 HDMI video output8 NMEA 01839 NMEA 2000Dimensions and Ports (AQUAMAP 12x2 Series)358.8 mm226.8 mm68.5 mm123 4 56789Item Description1 8-pin XDCR2 LAN3 Power4 Ground5 Video CVBS input - BNC6 GPS antenna - BNC7 HDMI video output8 NMEA 01839 NMEA 2000Typical System IntegrationNMEA 2000NetworkAntenna Radar PanoptixLAN2nd AQUAMAPTransducerAQUAMAPCameraMonitorTools Needed• Drill◦ Bail mount: drill bits appropriate for the surface and hardware◦ Flush mount: 14 mm (9/16 in.), 6 mm (1/4 in.) and 3.6 mm (9/64 in.) (withnut plate), or 3.2 mm (1/8 in.) drill bit (with no nut plate)• #2 Phillips screwdriver• Jigsaw or rotary tool• File and sandpaper• Marine sealant (recommended)Mounting ConsiderationsNOTICEThis device should be mounted in a location that is not exposed to extremetemperatures or conditions. The temperature range for this device is listed inthe product specifications. Extended exposure to temperatures exceeding thespecified temperature range, in storage or operating conditions, may causedevice failure. Extreme-temperature-induced damage and related conse-quences are not covered by the warranty.When selecting a mounting location, you should observe these consider-ations.• The location should provide optimal viewing as you operate your boat.• The location should allow for easy access to all device interfaces, such asthe keypad, touchscreen, and card reader, if applicable.• The location must be strong enough to support the weight of the deviceand protect it from excessive vibration or shock.• To avoid interference with a magnetic compass, the device should not beinstalled closer to a compass than the compass-safe distance value listedin the product specifications.• The location must allow room for the routing and connection of all cables.• The location must not be a flat, horizontal surface. The location should bein a vertical angle.The location and viewing angle should be tested before you install thedevice. High viewing angles from above and below the display may resultin a poor image.