Garmin DELZ 580 Owner's Manual

Getting StartedWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.• Update the maps and software on your device (Map andSoftware Updates, page 22).• Mount the device in your vehicle and connect it to power(Mounting and Powering the dēzl Device in Your Vehicle,page 1).• Acquire GPS signals (Acquiring GPS Signals, page 1).• Adjust the volume (Adjusting the Volume, page 2) anddisplay brightness (Adjusting the Screen Brightness,page 2).• Set up a vehicle profile for your truck.• Navigate to your destination (Starting a Route, page 3).dēzl 580 Device OverviewÀ Power keyÁ USB power and data portÂ Map and data memory card slotÃ Microphone for Voice Command or hands-free callingMounting and Powering the dēzl Device inYour VehicleWARNINGThis product contains a lithium-ion battery. To prevent thepossibility of personal injury or product damage caused bybattery exposure to extreme heat, store the device out of directsunlight.Before you use your device on battery power, you should chargeit.1 Plug the vehicle power cable À into the USB port on thedevice.2 Press the mount Á onto the suction cup Â until it snaps intoplace.3 Press the suction cup to the windshield, and flip the lever Ãback toward the windshield.4 Fit the tab on the top of the mount into the slot on the back ofthe device.5 Press the bottom of the mount into the device until it clicks.6 Plug the other end of the vehicle power cable into a poweroutlet in your vehicle.Turning the Device On or Off• To turn the device on, press the power key, or connect thedevice to power.• To put the device in power saving mode, press the power keywhile the device is on.While in power saving mode, the screen is off and the deviceuses very little power, but it can wake instantly for use.TIP: You can charge your device faster by putting it in powersaving mode while charging the battery.• To turn off the device completely, hold the power key until aprompt appears on the screen, and select Off.The prompt appears after five seconds. If you release thepower key before the prompt appears, the device enterspower saving mode.Acquiring GPS SignalsWhen you turn on your navigation device, the GPS receivermust collect satellite data and establish the current location. Thetime required to acquire satellite signals varies based on severalfactors, including how far you are from the location where youlast used your navigation device, whether you have a clear viewof the sky, and how long it has been since you last used yournavigation device. The first time you turn on your navigationdevice, it may take several minutes to acquire satellite signals.1 Turn on the device.2 Wait while the device locates satellites.3 If necessary, go to an open area, away from tall buildings andtrees.in the status bar indicates the satellite signal strength. Whenat least half the bars are filled, the device is ready for navigation.Status Bar IconsThe status bar is located at the top of the main menu. The statusbar icons display information about features on the device. Youcan select some icons to change settings or view additionalinformation.GPS signal status. Hold to view GPS accuracy and acquiredsatellite information (Viewing GPS Signal Status, page 24).Bluetooth®technology status. Select to view the Bluetoothsettings (Wireless Network Settings, page 20).Wi-fi signal strength. Select to change the wi-fi settings(Wireless Network Settings, page 20).Connected to hands-free calling. Select to place a phone call(Hands-Free Calling, page 13).Active vehicle profile. Select to view the vehicle profilesettings.Current time. Select to set the time (Setting the Time,page 21).Battery charge level.Sharing Dispatch and Track data. The number of invitedviewers appears on the icon. Select to open the Dispatchand Track app (Dispatch and Track, page 16).Getting Started 1