Garmin EDGE 830 Owner's Manual

Also see for EDGE 830: Owner's manual Owner's manual

Garmin EDGE 830 Owner's Manual Manual pdf 6 page image

2 Plug the small end of the USB cable into the USB port on thedevice.3 Plug the large end of the USB cable into an AC adapter or acomputer USB port.4 Plug the AC adapter into a standard wall outlet.When you connect the device to a power source, the deviceturns on.5 Charge the device completely.After you charge the device, close the weather cap.About the BatteryWARNINGThis device contains a lithium-ion battery. See the ImportantSafety and Product Information guide in the product box forproduct warnings and other important information.Installing the Standard MountFor the best GPS reception, position the bike mount so the frontof the device is oriented toward the sky. You can install the bikemount on the stem or the handlebars.1 Select a secure location to mount the device where it doesnot interfere with the safe operation of your bike.2 Place the rubber disk on the back of the bike mount.Two rubber disks are included, and you can select the diskthat best fits your bike. The rubber tabs align with the back ofthe bike mount so it stays in place.3 Place the bike mount on the bike stem.4 Attach the bike mount securely using the two bands .5 Align the tabs on the back of the device with the bike mountnotches .6 Press down slightly and turn the device clockwise until itlocks into place.Installing the Out-Front MountNOTE: If you do not have this mount, you can skip this task.1 Select a secure location to mount the Edge device where itdoes not interfere with the safe operation of your bike.2 Use the hex key to remove the screw from the handlebarconnector .3 Place the rubber pad around the handlebar:• If the handlebar diameter is 25.4 mm, use the thicker pad.• If the handlebar diameter is 31.8 mm, use the thinner pad.4 Place the handlebar connector around the rubber pad.5 Replace and tighten the screw.NOTE: Garmin®recommends tightening the screw so themount is secure, with a maximum torque specification of7 lbf-in. (0.8 N-m). You should check the tightness of thescrew periodically.6 Align the tabs on the back of the Edge device with the bikemount notches .7 Press down slightly and turn the Edge device clockwise untilit locks into place.Releasing the Edge1 Turn the Edge clockwise to unlock the device.2 Lift the Edge off the mount.Installing the Mountain Bike MountNOTE: If you do not have this mount, you can skip this task.1 Select a secure location to mount the Edge device where itdoes not interfere with the safe operation of your bike.2 Use the 3 mm hex key to remove the screw from thehandlebar connector .2 Introduction