Garmin FUSION XS Series Installation Instructions Manual
Also see for FUSION XS Series: Installation instructionsInstallation instructionsInstallation instructionsInstallation instructions
            |
Subwoofer WiringWhen connecting the subwoofer to your amplifier or source, observe the following considerations.• Speaker wire is not included with the subwoofer. You should use 12 AWG (3 through 4 mm2) speaker wire toconnect the subwoofer to the amplifier or source.• The leads on the subwoofer are terminated using male spade connectors. You should use female spadeconnectors (not included) to connect the speaker wire to the speaker leads for the best connection.• The subwoofer features a dual 2 Ohm voice coil that can be configured for 2.1 operation (two speakers andone subwoofer) when connected to a FUSION stereo with DSP capability (Configuring the Subwoofer for 2.1Operation, page 6).• You can use the following table to identify the polarity of the leads on the speaker.White Positive (+)Gray with a black stripe Negative (-)NOTE: Gray and white with a black stripe wires are connected to jumper terminals on the back of thesubwoofer. These wires must remain connected to the jumper terminals for normal use (4 Ohm) and shouldbe disconnected only when configuring the speaker for 2.1 operation.LED WiringConnecting the LED WiresYou can control the color of the LEDs by connecting the LED color wires to ground. You can splice the groundwire to multiple LED wires to customize the LED color.NOTE: This feature is available only on the sports model.NOTE: Instead of connecting the LED wires for one dedicated color, you can install a remote control to turn theLEDs on and off, change the color, and create lighting effects. See your FUSION dealer or support.garmin.comfor more information.The black wire on the LED cable is terminated with a 4 mm female bullet connector, and the color wires areterminated with 4 mm male bullet connectors. You can connect these to 4 mm bullet connectors on your wires(not included), or remove the bullet connectors to connect to the bare wires instead.1 Connect a positive wire to the black wire on the LED cable.2 Connect a ground wire to the wire on the LED cable according to the preferred LED color.LED Color LED Wire ColorRed RedGreen GreenBlue BlueYellow Red and greenMagenta Red and blueCyan Blue and greenWhite Red, green, and blue3 Route the positive and negative wires, and connect them to a power source (Connecting the LED Wires toPower, page 6).XS Series Subwoofer Installation Instructions 5 |
Related manuals for Garmin FUSION XS Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine