Garmin Fusion XS Series Installation Instructions Manual

Fusion®XS Series Marine Wake Tower Speakers InstallationInstructionsImportant Safety InformationWARNINGSee the Important Safety and Product Information guide in the product box for product warnings and otherimportant information.This device must be installed according to these instructions.Disconnect the vehicle's or vessel's power supply before beginning to install this device.CAUTIONContinuous exposure to sound pressure levels over 100 dBA may cause permanent hearing loss. The volume istypically too loud if you cannot hear people speaking around you. Limit the amount of time you listen at highvolume. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked.To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,cutting, or sanding.NOTICEWhen drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.It is strongly recommended that you have your audio system installed by a professional installer to ensureoptimum performance.You must read all installation instructions before beginning the installation. If you experience difficulty duringthe installation, go to www.fusionentertainment.com for product support.What's In the Box• Two wake tower can speakersMaterials and Tools Needed• 16 AWG (1.31 mm2) wire (speakers) (Speaker Wire Gauge Guide, page 2)• 20 AWG (0.5 mm2) wire (LEDs)• 3 A in-line fuse (LEDs)• Speaker mounting bracket (sold separately)1• Drill and 12 mm (1/2 in.) drill bit• Wire strippers• Solder and dual-wall heat-shrink tubing for wire connectionsNOTE: For customized installations, additional tools and materials may be needed.1 Various brackets are available for mounting these speakers on a wake tower bar or on a deck. See your Fusion dealer for more information.GUID-779EF88A-1B57-4670-8074-539F3565BD19 v2May 2021