20Unit OperationSetup Menu: Tools/Numbers TabsNoise Reject (continued)To change the Noise Reject Setting:1. Highlight the ‘Tools’ tab on the Setup Menu.2. Highlight the ‘Noise Reject’ selection field and press ENTER.3. Choose ‘Off,’ ‘Auto,’ or ‘Manual’ and press ENTER.To manually adjust the Noise Reject Setting:1. Select ‘Manual’ in the ‘Noise Reject’ field of the ‘Tools’ tab of the SetupMenu, then press ENTER. A slider will appear below the ‘Noise Reject’selection field.2. Use the UP/DOWN Arrows to highlight the slider, then press ENTER.3. Use the LEFT/RIGHT Arrows to manually adjust the Noise Reject Sliderto the desired setting, then press ENTER.Numbers TabThe ‘Num’ (Numbers) tab allows you to choose whether you wouldlike to see normal or large numbers on the chart. You can also configurethe unit to display ‘Battery Voltage,’ (water) ‘Temperature,’ and ‘Speed’ OverWater if the unit is equipped with capable sensors. You can also set up howthe unit finds the digital ‘Depth Number.’ To access the ‘Num’ tab, place thehighlight over it using the arrow keys.Number SizeThis setting determines the size of the numbers displayed in the‘Depth,’ ‘Temperature,’ ‘Battery Voltage’ and ‘Speed’ fields on the chart.To select Normal or Large Numbers:1. Highlight the ‘Num’ tab on the Setup Menu.2. Highlight the ‘Number Size’ selection field and press ENTER.3. Choose ‘Normal’ or ‘Large’ and press ENTER to accept the selection.Large NumbersNormal NumbersNoise Reject Manual Adjustment Slider