19Unit OperationSetup Menu: Tools TabTo change the Depth Line Setting:1. Place the highlight over the ‘Depth Line’ selection on the Adjustment Bar.2. Use the UP or DOWN Arrow to change the setting, press ENTER toaccept the change.FlasherWith the ‘Flasher’ tool active, a graphic Flasher representation will bedisplayed on the far right side of the chart. This graphic Flasher displaysstructure and bottom returns much the same as a true Flasher. You mayfind this feature particularly useful when using ‘Fish Symbols.’To Turn the Graphic Flasher on and off:1. Highlight the ‘Tools’ tab on the Setup Menu.2. Highlight the ‘Flasher’ selection field and press ENTER.3. Select ‘On’ or ‘Off’ and press ENTER to accept the selection.SimulatorThe ‘Simulator’ tool allows the unit to simulate the use of four differenttransducer configurations: ‘Depth Only’, ‘Temp’, ‘Speed’, or ‘Temp andSpeed’. These choices allow the user to view more accurate depictions ofactual unit operation. For details on using the simulator, see page 35.Noise RejectThe ‘Noise Reject’ tool helps filter unwanted noise from the chart. The‘Noise Reject’ tool can be turned ‘Off,’ set for ‘Auto’ (automatic) adjustmentor set for ‘Manual’ adjustment.Remember when setting the Noise Reject tool, the higher the noise rejectionsetting,themorelikelytheunitistonotshowfi shorstructure.Depth Line ActivatedGraphic Flasher ActivatedContinued on page 20www.reelschematic.comwww.reelschematic.com