Garmin Fishfinder 340C Owner's Manual

Also see for Fishfinder 340C: Quick reference Owner's manual Install guide Declaration of conformity Owner's manual

Fishfinder 340C Owner’s Manual 43APPendIx > M essAges And AlArMsMessages and AlarmsThe Fishfinder 340C uses an on-screen pop-up message system to alert youto unit operating characteristics. When a message appears, press ENTER toacknowledge the message and return to the page you were viewing.Anchor drag Alarm—you have drifted out of the specified distance range.battery Alarm—battery voltage has fallen below the value entered in theBattery Alarm setup.battery Voltage Is Too high—too much input voltage; the unit shuts off in10 seconds. Decrease the input voltage to 33 volts or less.boat Is Not moving Fast Enough to Calibrate—the boat is not moving fastenough for the speed wheel to provide a valid speed.Can’t Read Voltages That high, limited to Top of Range—the voltagevalue in the Battery Alarm setup is higher than the unit can read.Can’t Read Voltages That low, limited to bottom of Range—the voltagevalue in the Battery Alarm setup is lower than the voltage where the unitautomatically turns off.Can’t Send Waypoint—the unit cannot transmit the waypoint using theNMEA WPL sentence. Check the wiring.deep Water Alarm—the Deep Water Alarm depth has been reached.drift Alarm—the depth has changed by the amount of the Drift Alarm value.Fish Alarm—an icon appears and a beep sounds (if enabled) when a fish isdetected. This alarm does not show a message banner.NmEA depth Is below Transducer—you must enter an appropriate KeelOffset for the transducer.Shallow Water Alarm—the Shallow Water Alarm depth has been reached.Simulating Operation—the unit is in Simulator mode. This messagereappears after 2 minutes of inactivity. (If the unit does not detect a transducerattached, it automatically enters Simulator mode.)Sonar Failed, Unit Needs Repair—there is an internal problem with theFishfinder. Contact your dealer or Garmin Product Support to have the unitserviced.Timer Alarm—the Timer Alarm value has counted down to 00:00:00.Transducer disconnected, Sonar Turned Off—there is not a transducerattached, bad cable/transducer, or the transducer cable was disconnected.If the transducer cable is removed while the unit is on, reconnect and cyclepower.Water Speed Sensor Is Not Working—the speed sensor is not detected.Check the connections.Water Temperature Alarm—the Water Temperature Alarm setting hasreached a value above, below, inside, or outside of the specified values.