Fishfinder 340C Owner’s Manual 39U SING THE FISHFINDER 340C > PAUSING A SONAR OR FLASHER PAGETIME—the time of day, shown using your selected time format.TIMER—an alarm that counts down or up in the increments thatyou set in the Alarms System sub tab.TURN—the degrees that you must turn left or right to make yourdirection of travel match your bearing. Steer left (L) or right (R)until this reads 0 to go directly to your destination.VMG (velocity made good)—the rate of closure to a destinationbased on your current speed and course.VOLT—the current battery voltage input.WTR TEMP (water temperature)—the water temperature at thetransducer.XTE (crosstrack error)—how far off the chosen course you are,measured by your selected distance units. This indicates if you areto the left or right of the course.Pausing a Sonar or Flasher PageUse a paused screen to take a better look at sonar returns. Thedepth continues to update while the page is paused, but theFishfinder does not show any new sonar data until the Sonar Pageresumes scrolling. You might see a discontinuity from where thesonar information stops to where it starts again when you resumescrolling the screen.To pause and unpause the Sonar or Flasher Page:From the Sonar or Flasher Page, press PAUSE to stop thescrolling. Press PAUSE again (or QUIT) to resume scrolling.