Garmin Fusion MS-RA60 Installation Instructions Manual

Fusion®MS-RA60 Installation InstructionsImportant Safety InformationWARNINGFailure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poorproduct performance.See the Important Safety and Product Information guide in the product box for product warnings and otherimportant information.This device must be installed according to these instructions.Disconnect the vessel's power supply before beginning to install this product.Before applying power to this product, make sure it has been correctly grounded, following the instructions inthe guide.CAUTIONTo avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,cutting, or sanding.NOTICEWhen drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.You must read all installation instructions before beginning the installation. If you experience difficulty duringthe installation, contact Fusion Product Support.What's In the Box• Mounting gasket• Four 6-gauge, self-tapping screws• Two screw covers• Power and speaker wiring harness• Auxiliary-in, line-out, and subwoofer-out wiring harnessTools Needed• Phillips screwdriver• Electric drill• Drill bit (size varies based on surface material and screws used)• Rotary cutting tool or jigsaw• Silicone-based marine sealant (optional)TA-2021/0772GUID-3453BF25-825C-403E-917D-EF24C7294A81 v2December 2021