Garmin G1000 NAV III Line Maintenance Manual

Contents

Page 4-18 G1000 Nav III Line Maintenance ManualRev. L 190-00352-00For software/configuration troubleshooting see Section B.4, otherwise continue to Section 4.4.5.4.4.2 GMU 44 Software (GDU software version 6.01 and earlier)1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.2. Apply system power, insuring both MFD and PFD are in Configuration Mode.3. Press the CLR key at the “Do you want to update system files?” prompt.4. Rotate the small FMS knob to the SOFTWARE UPLOAD page.5. Turn on the cursor by pressing the FMS knob.6. Rotate the small FMS knob to select GMU software.7. Press the LOAD softkey.8. Press the ENT key at the “BEGIN FILE UPLOAD?” prompt.9. Confirm update completion and press the ENT key.10. Confirm correct software part number and software version on the SYSTEM STATUS page.For software/configuration troubleshooting see Section B.4, otherwise continue to Section 4.4.5.4.4.3 GRS 77 Software (GDU software version 7.01 and later)1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.2. Start the G1000 system in Configuration mode, if the system is not already in Configuration mode.3. Press the CLR key at “DO YOU WANT TO UPDATE SYSTEM FILES?” prompt.4. Using the FMS knob go to the System Upload page on the PFD.5. Activate the cursor and highlight the appropriate airframe in the AIRFRAME field.6. Press the ENT key.7. Highlight the appropriate full configuration in the FILE field.CAUTIONLoading the wrong software into GIA63/63W units may cause an inoperable condition thatis not covered by warranty. Refer to Section 4.3 of this manual to identify which type of GIA63 (WAAS or Non-WAAS) is installed in the aircraft, and how to choose the correct WAAS orNon-WAAS software file. Loading the incorrect software may make the GIA 63 or GIA 63Winoperable and necessitate returning the unit to Garmin for non-warranty repair. No warningappears if the wrong software is selected.