G1000 Nav III Line Maintenance Manual Page B-1190-00352-00 Rev. LAPPENDIX B G1000 SYSTEM SOFTWARE & CONFIGURATIONThe following information is intended to serve as an example for a complete reconfiguration of the G1000system. Software part numbers and software versions shown are not intended to be airframe specific. Foractual software versions and part number refer to Page i.CAUTIONDO NOT ALLOW POWER TO BE REMOVED FROM THE SYSTEM WHEN LOADINGSOFTWARE! Connect a ground power unit to the aircraft for software loading. Do not relysolely on the aircraft batteries to prevent loss of power during the software loading process. AllGDUs should be in the same mode (configuration or normal), unless instructed differently by theprocedure. Remove power only when instructed by the procedure.CAUTIONRemove Supplemental Data Cards (010-00330-41 or 010-00330-42) from the lower slot of theGDUs before loading any software. Supplemental Data Cards left inserted can become corrupt,making them unusable. Replacing corrupt cards is not covered under warranty.NOTERefer to the Cessna Maintenance Manual for approved software versions and part numbers.NOTEGarmin recommends the use of SanDisk or Toshiba SD cards to load G1000 software andconfiguration files. If software loading problems occur when using another brand of card, replacethe card with a SanDisk or Toshiba card and reattempt the software load.
