G1000 Supplemental Maintenance Manual Page 3-37Textron Nav III Series Revision 3190-02128-04databases are synchronized, the system will verify them for use by showing “Verifying” inthe Standby column. After the databases are verified, a cyan double arrow symbol willappear between the Standby and Active columns to show which databases will betransferred to Active use on the next power cycle or restart.Figure 3-10, MFD Aux - Database Page DB TransferWhen all database updates are complete, the Database Update field at the top of thescreen will say, “Restart avionics to activate selected standby databases.” If the engineis not running, a Restart softkey appears at the bottom of the MFD. Press Restart tocycle power on the displays. If the Restart softkey is not present, turn OFF PFD andMFD.Remove the database update card from the top slot of the MFD.Turn ON the displays.The displays may state they are verifying databases at power-up. If so, follow the on-screen instructions to continue.Go to the MFD Aux - Databases page and verify the uploaded databases transferredfrom the Standby column to the Active column. If any did not transfer, follow these stepsto initiate a manual transfer -a. Push the FMS knob on the MFD controller to turn on the cursor.
