190-00692-00 Rev. B Garmin G1000 Pilot’s Guide for Piper PA32 3-9ENGINE INDICATION SYSTEMLEAN DISPLAYNOTE: Follow the engine manufacturer’s recommended leaning procedures in the AFM.NOTE: Turbocharged Piper models are not equipped with the Lean Assist function.The EIS Lean Display provides information and a user interface to perform engine leaning. Exhaust gas(EGT) and head (CHT) temperatures for each cylinder are displayed in bar graph form with a readout forthe temperature of the selected cylinder shown below each graph. By default, the cylinder with the hottesttemperature is selected (number highlighted in light blue) when the LEAN Softkey is pressed. Turbine inlettemperature (TIT) is shown in place of EGT for turbocharged aircraft.Bars for cylinders with temperatures in the normal range are shown in white. On the CHT Bar Graph, awarning condition for a cylinder is indicated in red.Accessing the EIS Lean Display:1) Press the ENGINE Softkey.2) Press the LEAN Softkey.3) To return to the default Engine Display, press the ENGINE or BACK Softkey.The CYL SLCT Softkey becomes available after pressing the LEAN Softkey. The CYL SLCT Softkey can beutilized to cycle through the cylinders and obtain information about a cylinder, highlighted in light blue on thebar graph(s). This softkey is disabled when the ASSIST Softkey is pressed or when a cylinder experiences awarning (red) condition; this softkey remains disabled until the temperature returns to normal.Monitoring the desired cylinder’s temperatures:From the Lean Display, press the CYL SLCT Softkey to cycle through each cylinder and view its temperatureinformation. The selected cylinder number is highlighted in light blue.An Engine Leaning Assist Function is available to assist in the leaning process for normally-aspirated aircraft.When the ASSIST Softkey is pressed, the system automatically switches to the first peak obtained and displaysthe temperature deviation from peak (∆PEAK) in degrees Fahrenheit below the EGT readout for the peakedcylinder. When a cylinder peaks, its number is indicated in light blue and its peak is represented by a lightblue bar on the EGT bar graph. Lean Assist continues to monitor this cylinder unless the temperature for thecylinder exceeds peak. If peak is exceeded, Lean Assist is reset.Selecting the Engine Leaning Assist Function (normally-aspirated aircraft):From the Lean Display, press the ASSIST Softkey to identify the peak. The EGT for the selected cylinder (numberhighlighted in light blue) and its deviation from peak temperature are displayed beneath the EGT Bar Graph.
