190-00726-00 Rev. A Garmin G900X Pilot’s Guide 4-35AUDIO PANEL AND CNS4.6 AUDIO PANEL PREFLIGHT PROCEDURENOTE: If the pilot and/or copilot are using headsets that have a high/low switch or volume control knob,verify that the switch is in the high position and the volume control on the headsets are at maximum volumesetting. On single-pilot flights, verify that all other headsets are not connected to avoid excess noise in theaudio system.NOTE: When the MAN SQ Key is pressed, the ICS squelch can be set manually by the pilot and copilot. Ifmanual squelch is set to full open (SQ annunciated and the knobs turned counterclockwise) backgroundnoise is heard in the ICS system as well as during COM transmissions.After powering up the G900X System, the following steps will aid in maximizing the use of the Audio Panelas well as prevent pilot and copilot induced issues. These preflight procedures should be performed each time apilot boards the aircraft to insure awareness of all audio levels in the Audio Panel and radios.Figure 4-44 Audio Panel ControlsPilot andCopilot ICSIsolation KeysPilot Volumeor ManualSquelchAutomatic/ManualSquelchVolumeAnnunciationSquelchAnnunciationCopilot/PassengerVolume orManual SquelchSetting the Audio Panel during preflight:1) Verify that the PILOT and COPLT Annunciators are extinguished.2) Verify that the MAN SQ Annunciator is extinguished.3) Turn the PILOT/PASS Knobs clockwise two full turns. This will set the headset intercom audio level to maxvolume (least amount of attenuation).4) Adjust radio volume levels (COM, NAV, etc.) to a suitable level.5) Adjust the PILOT/PASS Knob volume to the desired intercom level.Once this procedure has been completed, the pilot and copilot can change settings, keeping in mind the notesabove.
