Garmin GLADIATOR TR-1 Installation Setup Manual

Also see for Gladiator TR-1: Installation and user manual Owner's manual Owner's manual

Garmin GLADIATOR TR-1 Installation Setup Manual Manual pdf 13 page image

13ProtectionLocate the Pump Unit, the ECU and the Compass Ball in a place where they will not be submerged or exposed to washdown. Spray the installed components with a protective corrosion prohibitive like Bo-Shield or Corrosion X, etc.Hydraulic ConnectionsBefore starting the hydraulic installation, please verify the type of hydraulic steering in the boat. If it does not match thehydraulic layouts in this manual, call technical support at 1-866-559-0229 for specific installation procedures. Examples ofsteering systems that may need special instructions: Capilano, Hynautic, Latham.Do not use Teflon tape on any hydraulic fittings. However, for leak free hydraulic system, we do advise you to use anappropriate thread sealant such as, Loctite “Pro Lock” multipurpose anaerobic gel, part number 51604, or equivalent on allpipe threads.It is TR-1’s recommendation to only use hose with machine crimped on fittings, or field replaceable fittings that havea minimum of 1,000 PSI rating.It is recommended that before connecting the hydraulic lines to the pumpset, ensure all the hydraulic lines in the steeringsystem have been flushed and that the hydraulic oil is free of any contamination, which may enter the pumpset or ShadowDrive valve and cause it to fail.Air in the hydraulic system will cause the autopilot not to function properly. It’s important to bleed the system thoroughly.Follow the steering manufacturers instructions on bleeding procedures before proceeding with installation. You can findmost of these instructions on the internet.Hydraulic hoses must be protected from chafing, and installed in such a way that they will not come in contact with sharpobjects such as fasteners or edges. Hydraulic lines must be secured wherever possible to prevent hose vibration while theautopilot hydraulic pump is running.Magnetic EnvironmentThe Compass Ball has a very sensitive compass and gyro in it. Do not mount the ball near magnetic material, magnets(speakers and electric motors), or high current carrying wires. Movable or changing magnetic disturbances such as anchors,anchor chain, and wiper motors, tool boxes and the autopilot pump should be kept at least 24” away. A small handheldcompass may help in locating a magnetic free environment.The Shadow Drive must not be mounted within 12” of any magnetic material such as speakers or electric motors, includingthe autopilot pump.Strain Relief and Cable ProtectionDo not let the connectors on the ECU be the sole support for the cables connected to them. Use tie wraps to tie the cablesdown.Don’t run cables and hoses over sharp edges. Use grommets in through holes to protect cables.MaintenanceJust like other electronic equipment, the TR-1 Gladiator should be protected against corrosion. Since most of the componentsare out of sight, out of mind, you should coat all components with a spray on, electronic grade, protective corrosion inhibitorlike Bo-Shield, Corrosion X or equivalent. This should be done after installation, and repeated every six months for bestprotection, more often if components and connections are exposed to salt water. Check battery connections and fuse holderfor corrosion, and make sure all connections are tight.