Garmin GPSMAP 546 Owner's Manual

Also see for 531s - Transducer: Important safety information Owner's manual Installation instructions Reference guide Owner's manual

Contents

Garmin GPSMAP 546 Owner's Manual Manual pdf 72 page image

Appendix66 GPSMAP 400/500 Series Owner’s Manualeither been disconnected or the unit has lost communication with the sonardevice for some other reason.Track already Exists [Track Name]—you entered a saved track name thatalready exists in memory. Modify the track name or delete the existing track.Track Log full—the track log is full and track recording has been turnedoff. To record more track points, you need to clear the track log and turn trackrecording on. This only appears when the track recording setting is set to “StopWhen Full.”Track Memory is full, Can’t Create Track—the track log memory is full.No additional track log data can be stored without deleting old data to creatememory space.Track Truncated—a complete uploaded track does not fit into memory. Theoldest track log points were deleted to make space for the most recent data.Transducer disconnected, Sonar Turned Off—there is not a transducerattached, there is a bad cable or transducer, or the transducer cable wasdisconnected. If the transducer cable is removed while the unit is on, reconnectand cycle power.Transfer Complete—the unit has finished uploading or downloadinginformation to the connected device.User Card Not found, Please insert Card—attempted to transfer user datawithout an SD card containing user data being present in the SD card slot.warning: auto-guidance route starting and ending position moved due tosafe depth settings—the auto-guidance route was calculated but the startingand ending positions were moved because of safe depth settings.water Speed Sensor is Not working—the speed sensor is not detected.Check the connections.water Temperature alarm—sonar has reported a temperature above, below,inside, or outside the specified values.waypoint already Exists—you entered a waypoint name that already existsin memory. Modify the waypoint name or delete the existing waypoint.waypoint Memory full—you have saved the maximum number ofwaypoints. Delete unwanted waypoints to make space for new entries.Capturing ScreenshotsYou can capture a screenshot of any screen displayed on your unit as a bitmap(.BMP) file and then transfer it to your computer.To capture screenshots:1. Insert an SD card into the SD card slot on the front of the unit.2. Select Configure > System > beeper/display.3. Select Screenshot Capture to turn screenshot captures On.4. When you are on a screen you want to capture, press and hold the HOMEbutton for at least six seconds.5. Select OK when the Screenshot Taken window is displayed.To copy the screenshots to your computer:1. Remove the SD card from the chartplotter and insert it into an SD cardreader that is attached to a computer.2. From Windows Explorer, open the Garmin\scrn folder on the SD card.