190-01499-02 GTX 3X5 Transponder TSO Installation ManualRev. 4 Page C-3C.2 GPS SourcesTable C-2 GPS SourceNotes:[1] Installations with no TIS.[2] Installations with TIS (GTX 335 only).[3] Installations with GDU software v15.00 or later.[4] Installations with GDU software prior to v15.00.Manufacturer Model DataFormatInterfaceConfigurationGTX 3X5Configuration NotesGarminG950/G1000 RS-232GTX 33ES #1 [1]ORGTX 33ES #1 w/ TIS [2]REMOTE FMT 1 [1,3]ORREMOTE FMT 2 [2,3] Refer to the STC installation manual for guidance. Note that the primarypurpose of this interface is transponder control, however this formatalso includes GPS data. Refer to table C-9.LGCY REMOTE 1 [1,4]ORLGCY REMOTE 2 [2,4]Internal N/A N/A Refer to section 6.8.GTN 6XX/7XX RS-232 ADS-B OUT + ADS-B + FMT 1HSDB ADS-B In Source: GTX GTN - Enabled Applicable to GTX 345 installations only.GNS 400W/500W RS-232ADSB TFCGNSApplicable to GTX 345 installations only. Note that the primary purposeof this interface is for ADS-B In Data, however this format also includesGPS data. Refer to table C-1.ADSB TFC WXADS-B OUT + ADS-B + FMT 1 Supports GPS data only.GNS 480 RS-232GTX + [1] REMOTE FMT 1 [1] Note that the primary purpose of this interface is transponder control,however this format also includes GPS data. Refer to table C-9.GTX w/TIS+ [2] REMOTE FMT 2 [2]ADS-B OUT + ADS-B + FMT 1GTX 3X5 RS-232 ADS-B + FMT 1 N/AADS-B + FMT 2 ADS-B + FMT 2GDL 84/88 withGPS/SBAS ARINC 429 743A RINC 743A
