9ReferenceTo change the Channel and/or Squelch Code:1. Using the THUMB STICK, highlight the ‘Channel’ or ‘Code’ field and then press the THUMBSTICK IN to show a list of available channels/squelch codes.2. Move the THUMB STICK UP or DOWN to scroll through the selections. Because not all theitems fit in the window, a slider bar on the right side indicates your current position in thelist.3. Once you have highlighted the desired selection, press the THUMB STICK IN.Scanning and MonitoringThe ‘Scan’ option allows you to scan through the available channels for voice activity. Asthe unit scans and receives a signal (or if you transmit), it stops on that channel/squelch codefor a few seconds, then continues scanning. When the Rino 130 is scanning and it receives anincoming signal, the Rino 130 automatically decodes the Squelch Code used by the incomingsignal. The Rino 130 then uses that Squelch Code when it transmits back to that unit.You may use the Set Scanlist option to pick which channels/squelch codes to scan. Scan-ning through the all the channels can take time: Selecting only specific channels/squelch codesdecreases the scan time and helps prevent the chances of missing a transmission. The Scanlistalso has Option Menu choices to ‘Scan Current Codes’ or ‘Scan All Codes’. Choosing ‘ScanCurrent Codes’ scans only the Channel and Squelch Code combination in memory.Radio PageChoose from 38 squelchcodes. Setting the unit tozero will allow you to hearall transmissions on thatchannel, but you must beon the same squelch code toradio back.
