Garmin VIRB 360 Owner's Manual
                      | |
Contents
|
3 Plug the small end of the USB cable into the micro-USB portÁ on the camera.NOTICEUse only the included micro-USB cable or another cable witha straight micro-USB connector. Do not use a micro-USB cable with an right-angle connector. A right-angleconnector may cause damage to the recessed micro-USB port.4 Plug the large end of the USB cable into a USB wall chargeror a computer USB port.NOTE: For the best results, a USB wall charger that providesat least a 2 A power output is recommended. ManyUSB power adapters for smartphones or tablets may becompatible.When you connect the device to a power source, one statusLED  turns solid red.5 Charge the battery.It takes approximately two hours to charge the battery to 80%capacity, and approximately three hours to fully charge thebattery. When the battery is fully charged, the red status LEDturns off.Turning On the CameraHold POWER.The status LEDs flash green when the camera is on.Turning Off the CameraNOTICETo prevent loss of data, always turn off the camera beforeremoving the battery.NOTE: You cannot turn off the camera while recording video.1 If necessary, move the recording switch backward to stoprecording video.2 Hold POWER.The camera saves your data and turns off.If you need to remove the battery, wait until the screen andstatus LEDs turn off before removing the battery.Turning the Camera On and Off Using the RecordingSwitchYou can use the recording switch to turn the camera on andimmediately start recording video. If you turn the camera onusing the recording switch, it turns off automatically when youstop the recording using the recording switch. This featureallows you to start and stop recording quickly, whileautomatically turning off the camera to conserve battery powerwhen you are not recording.NOTE: The camera does not turn off using the recording switchunless you use the recording switch to turn it on.1 With the device turned off, move the recording switchforward.The device turns on and starts recording video.2 When you are finished recording, move the recording switchbackward.The device stops recording and turns off.Home Screen OverviewThe home screen provides at-a-glance details about theremaining memory card space and current settings of yourdevice.À Displays the photo mode.Á Displays the sensor status and remaining battery capacity. IncludesANT+®sensors, Bluetooth®, Wi‑Fi, and GPS. Displays the video mode.à Displays the remaining memory card space for video recording.Status Bar IconsIcons appear at the top of the home screen.• A flashing icon means the device is searching for a signal.• A solid icon means the signal is acquired or the wirelessdevice is connected.GPS statusWi‑Fi technology statusBluetooth technology statusANT+ sensor statusBattery levelMain MenuFrom the home screen, select or to scroll through the mainmenu.Video Mode: Sets the video shooting mode (Video Modes,page 4).Photo Mode: Sets the photo shooting mode (Photo Modes,page 5).Lens Mode: Enables one or both lenses, and sets the field ofview (Lens Modes, page 4).Wireless: Allows you to connect to other devices, includingmobile devices, Bluetooth microphones and sensors, ANT+sensors, and compatible Garmin devices and remotes.Setup: Allows you to set up camera features, change systemsettings, and view system information (Setup Menu,page 13).Camera MountsAssembling the Tripod and CradleYou can use the universal tripod cradle to attach the camera tothe included tripod or a standard camera tripod.2 Camera Mounts |
Related manuals for Garmin VIRB 360
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine