Warning: The terms of the Garmin warranty require that the power cable with bare wire leads beinstalled by experienced installers having the proper knowledge of automotive electrical systems andskill in the use of special tools or hardware required for installation.1: Connect Power to the MountSelect a suitable and secure location to mount the zūmo on your motorcycle based on availablepower sources and safe cable routing.Bare wires withinline fuse forpower connectionPower connectorAbout connecting audioStandard jacks for microphone (2.5 mm) and audio out (3.5 mm) are located on the left side ofthe mount (under a weather cap). When connecting your audio system to the zūmo, be sure toconsider the pathways needed to route the necessary cables. For information about hands-freeaudio and phone options, refer to the zūmo 500/550 Quick Reference Guide and the zūmo 500/550Owner’s Manual on disk.2: Install the Handlebar BaseThe zūmo includes parts for two handlebar installationsolutions. Custom mounts can require additionalhardware (www.ram-mount.com).A) To install the U-bolt and handlebar base:1. Place the U-bolt around the handlebar, and threadthe ends through the handlebar base.2. Tighten the nuts to secure the base. Do notovertighten.note: The recommended torque is 50in-lb. Donot exceed maximum torque of 80in-lb.B) To install the handlebar base tothe clutch/brake clamp bracket:note: Both 1/4” standard and M6bolts are included. Match the size ofthe factory bolts on your clutch/brake clamp bracket.1. Remove the two factory bolts on yourclutch/brake clamp bracket.2. Thread the new bolts through thehandlebar base, spacers, and clamp bracket.3. Tighten the bolts to secure the base.zūmo™ 500/550 I nstallatIon sheetClutch/brakeclamp bracketHandlebarbaseSpacersHandlebar baseHandlebarU-boltGarmin® is a trademark of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. zūmo™ is atrademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission ofGarmin.March 2007 Part Number 190-00697-03 Rev. E Printed in Taiwan