37Setup PageThe eTrex bearings will correspond to a compass if the eTrex is set to magnetic north.Due to errors introduced when map makers flatten the earth’s sphere onto paper, not all ofthe grid lines drawn on the map point exactly to the north pole, so the north indicated bythe grid lines is called ‘Grid North’ (GRID). But, the difference is usually small enough that‘Grid’ north can be considered the same as True North for travelling on land. If necessary, youcan select a ‘User-Defined Grid’ (USER) to correct for the difference between Grid Northand True North manually.To change the North Reference:1. Press the PAGE Button and switch to the ‘MENU’ Page. Use the UP and DOWN Buttonand highlight the ‘SETUP’ field. Press ENTER. The ‘SETUP’ Page appears.2. Press the UP or DOWN Button to select ‘UNITS.’ Press ENTER. The ‘UNITS’ Page appears.3. Press the UP or DOWN Button and select the ‘NORTH REF’ field. Press ENTER.4. Press the UP or DOWN Button to select the desired reference (TRUE, MAG, GRID, orUSER). Press ENTER. The desired North Reference is selected.5. Press PAGE to return to the page of your choice.VarianceThe eTrex automatically lists the variance between Grid North and True North for the selectedNorth Reference grid. If you select a user-defined grid, you can enter the variance manually.To enter Variance manually:1. From the MENU Page, press the UP or DOWN button to highlight ‘SETUP.’ Press ENTER.2. Press the UP or DOWN button to select ‘UNITS.’ Press ENTER. The UNITS Page appears.3. Press the UP or DOWN button to select the ‘VARIANCE’ field. Press ENTER.4. Press the UP or DOWN button to select ‘INCHES’ or ‘MILLIBARS.’ Press ENTER. PressPAGE to select the page of your choice.Units PageWhile it should rarely be needed the user can manuallyadjust the variation/declination by selecting USER in theNorth Reference field.With a USER-defined grid selected, you can manually set thevariance by highlighting the Variance field, pressing ENTERand inputting a new angle.