Garmin nuviCam Owner's Manual

Also see for camper 660: Owner's manual Quick start manual

Garmin nuviCam Owner's Manual Manual pdf 5 page image

Getting StartedWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.• Install the camera memory card (Installing the Dash CameraMemory Card).• Update the maps and software on your device (UpdatingMaps and Software with Garmin Express).• Mount the device in your vehicle and connect it to power(Mounting and Powering the nüviCam Device in YourVehicle).• Align the dash camera (Aligning the Camera).• Acquire GPS signals (Acquiring GPS Signals).• Adjust the volume (Adjusting the Volume) and displaybrightness (Adjusting the Screen Brightness).• Navigate to your destination (Starting a Route).Installing the Dash Camera Memory CardBefore the device can record video from the integrated dashcamera, you must install a camera memory card. The camerarequires a microSD™ or microSDHC memory card up to 64GBwith a speed rating of class 4 or higher. You can use theincluded memory card, or you can purchase a compatiblememory card from an electronics supplier.1 Insert a memory card À into the camera memory card slot Á.NOTE: If you install the memory card into the incorrect slot,the camera cannot record video.2 Press it in until it clicks.Mounting and Powering the nüviCam Devicein Your VehicleWARNINGThis product contains a lithium-ion battery. To prevent thepossibility of personal injury or product damage caused bybattery exposure to extreme heat, store the device out of directsunlight.Both the device and its mount contain magnets. Under certaincircumstances, magnets may cause interference with someinternal medical devices, including pacemakers and insulinpumps. Keep the device and its mount away from such medicaldevices.NOTICEBoth the device and its mount contain magnets. Under certaincircumstances, magnets may cause damage to some electronicdevices, including hard drives in laptop computers. Use cautionwhen the device or its mount is near electronic devices.Before you use your device on battery power, you should chargeit.1 Press the mount À onto the suction cup Á until it snaps intoplace.2 Open the lever Â, press the suction cup to the windshield,and flip the lever back toward the windshield.The lever must be oriented toward the top of the windshield.3 Extend the suction cup arm Ã.4 If necessary, rotate the mount so the Garmin®logo facesright-side up.5 Plug the vehicle power cable Ä into the port on the mount.6 Place the back of the device onto the mount.7 Plug the other end of the vehicle power cable into a poweroutlet in your vehicle.Acquiring GPS SignalsTo navigate with your device, you must acquire satellites. inthe status bar indicates the satellite signal strength. Acquiringsatellites can take several minutes.1 Turn on the device.2 Wait while the device locates satellites.3 If necessary, go outdoors to an open area, away from tallbuildings and trees.Status Bar IconsThe status bar is located at the top of the main menu. The statusbar icons display information about features on the device. Youcan select some icons to change settings or view additionalinformation.GPS signal statusBluetooth®technology status (appears when Bluetooth isenabled)Current timeGetting Started 1