Garmin zumo 390LM Owner's Manual

Also see for zumo 300 Series: Installation instructions Owner's manual Quick start manual Declaration de conformite

Getting StartedWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.Mounting Your Device in a MotorcycleAbout the Powered Mount CablesWARNINGGarmin strongly recommends having an experienced installerwith the proper knowledge of electrical systems install thedevice. Incorrectly wiring the power cable can result in damageto the vehicle or the battery and can cause bodily injury.See the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.The device must be mounted in a suitable and secure locationon your motorcycle, based on available power sources and safecable routing.À Motorcycle cradleÁ Bare wires with inline fuse for power connection (to motorcyclepower)Installing the Handlebar BaseThe device includes parts for two handlebar installationsolutions. Custom mounts can require additional hardware(http://www.ram-mount.com).Installing the U-bolt and Handlebar Base1 Place the U-bolt À around the handlebar Á, and thread theends through the handlebar base Â.2 Tighten the nuts to secure the base.NOTE: The recommended torque is 50 lbf-in. Do not exceedtorque of 80 lbf-in.Installing the Handlebar Base to the Clutch-Clamp or Brake-Clamp Brackets1 Remove the two factory bolts on your clutch-clamp or brake-clamp bracket À.NOTE: Both 1/4 in. standard and M6 bolts are included.Match the size of the factory bolts on your clutch-clamp orbrake-clamp bracket.2 Thread the new bolts Á through the handlebar base, spacersÂ, and clutch-clamp or brake-clamp bracket.3 Tighten the bolts to secure the base.Attaching the Power Cables to the Motorcycle Mount1 Thread the power cable connector À through the top of theopening in the motorcycle mount.2 Slide the cable down to the bottom of the opening Á and pullthe cable back until it is snug.3 Screw the black screw Â into the back of the mount Ã tohold the cable in place.4 Thread the weather cap Ä through the top hole and press itinto the hole.Getting Started 1