Garmin zumo 390LM Owner's Manual

Also see for zumo 300 Series: Installation instructions Owner's manual Quick start manual Declaration de conformite

Attaching the Base Plate to the Motorcycle MountNOTICEDirect, sustained contact with the base plate, or any part of themotorcycle, may damage the mount over time. To prevent thiskind of damage, you must place the mounting spacers betweenthe mount and base plate, and make sure that no part of thedevice or mount touches the motorcycle.1 Thread the M4 x 40 mm panhead screws À through thewashers Á, cradle, spacers Â, and base plate Ã.2 Tighten the nuts to secure the base plate.Attaching the Base Plate to the Handlebar Base1 Align the ball of the handlebar base À and the ball of thebase plate Á with the double-socket arm Â.2 Insert the ball into the double-socket arm.3 Tighten the knob slightly.4 Adjust for optimal viewing and operation.5 Tighten the knob to secure the mount.6 Align the ball of the base plate attached to the cradle Â withthe other end of the double-socket arm.7 Repeat steps 2–4.Installing Your Device in the Motorcycle Mount1 Fit the bottom of your device into the cradle.2 Tilt the device back until it snaps into place.NOTE: If the latch on top of the mount stays up after youinsert the device, press it down.Removing Your Device from the MotorcycleMount1 Press the button on the side of the mount.2 Lift out the device.3 On the motorcycle mount, place the weather cap on thepower connector in the center of the cable (page 1).Mounting Your Device in an AutomobileNOTICEBefore mounting the device, check the local laws pertaining towindshield mounting.WARNINGThis product contains a lithium-ion battery. To prevent thepossibility of personal injury or product damage caused bybattery exposure to extreme heat, store the device out of directsunlight.Do not use the suction cup mount on a motorcycle.See the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.1 Pull back the weather cap on the back of the cradle.2 Plug the automotive power cable À into the mini-USBconnector Á under the weather cap.3 Remove the clear plastic from the suction cup.4 Clean and dry your windshield and the suction cup with alint-free cloth.5 Press the suction cup Â to the windshield, and flip the leverÃ back toward the windshield.6 Snap the cradle Ä onto the suction cup arm.2 Getting Started