Gastroback 41406 Instructions For Use Manual

Also see for 41406: Instructions for use

Gastroback 41406 Instructions For Use Manual Manual pdf 34 page image

345. Process the wrapping mixture in the mincer with the attached chopper attachments. The fin-ished product will be one long wrapping. Cut the wrapping into convenient seize.6. Freeze the wrapping shortly.7. Fill the wrapping with the filling mixture and fry the wraps with some olive oil until it hasthe favoured browning.CARE AND CLEANINGWARNING: Never hold your face or other body parts over the feed chute when the motoris running because little pieces of food could be thrown out of the feed chute. Never putforeign substance or hard objects into the feed chute.Before the mincer is used for the first time and after each usage, all parts – with the exceptionof the motor block – must be thoroughly cleaned in warm soapy water. In case of blockagework according to the instructions ´Trouble shooting guide`.DISASSEMBLE THE APPLIANCEWARNING: To avoid injury and damages of the appliance turn the applianceoff (pressing the on-/off button first and then the power button) and thenwait for approx. 6 seconds to be certain that the motor is no longer run-ning. Always pull the plug before you start disassembling or cleaning theappliance.1. Switch off the mincer and disconnect the power supply cable from the mains. Check thatthe motor has completely stopped.2. Take the pusher and the feed pan of the feed chute.3. Press the release button and turn the worm housing clockwise until you can take the wormhousing off the appliance without resistance.4. Unscrew the closing ring turning it counterclockwise.5. Remove the closing ring of the worm housing and take the inner unit (such as the worm,crossed-blade knife and grinding disc, Kebbe attachment, sausage attachment or cookie attach-ment) off the worm housing.TIP: If the tools are stucked knock the mincer carefully on a stable cutting board. The grindingdisc should be facing up.ATTENTION: Be careful not to damage your bench top, the cutting board or the mincer.6. Remove meat residues.Operate as described:ATTENTION: Never put the appliance or parts of the appliance in the dish-washer or use abrasives for cleaning! This will cause discolouration and cor-rosion.7. Wash all parts thoroughly in hot soapy water. Do not use aggressive detergents. The parts