Gemini 7853 User Manual

Contents

Gemini 7853 User Manual Manual pdf 6 page image

PAG.10 PAG.1120 seconds after the engine starting up, the alarm will immobilize the vehicle'sengine; two seconds later the siren will be activated at high volume, and thedirection indicators will start blinking repeatedly.This signalling will continue for a minute and, after this time, the siren will bedeactivated; the turn signals will continue blinking until the anti-hijackingfunction is disabled.To deativate the function insert the electronic key in the receptacle.In alarm condition, this implies the activation of the siren for just 2,5 secondsrather than the standard 30 seconds.This considerably reduces power consumption while preserving the vehicle'sbattery, and it reduces the environmental acoustic pollution.When the alarm is activated, providing an alarm condition is generated (i.e. thevehicle is accidentally hit), the siren will be activated for about 2,5 seconds.This condition of pre-alarm will be activated for the first 3 alarm causes.Indeed, from the fourth cause on, the siren will be activated for about 30seconds.The alarm cycles will be reset every time the alarm is deactivated or when thepanic alarm is activated.This function protects the vehicle in case the alarm would be unintentionallydeactivated.The alarm is activated by the user, then unintentionally deactivated by thesame user (e.g. the relevant button on the remote control is pressed).The user, unconscious about this, will leave the vehicle unprotected, althoughbeing sure of the contrary.35 seconds after this unintentional deactivation, the alarm will automaticallyreactivate, signalling this with the standard acoustic and optical signals.5.6 - PRE-ALARM5.7 - ANTI-DISTRACTION(first 3 alarm cause only)FUNCTIONNINGFUNCTIONNING5.3 - SHOCK SENSOR5.5 - ANTI-HIJACKING FUNCTION. ..The procedure can be interrupted, by turning on the ignition switch within 35”.If the trunk is open, the passive arming time will be interrupted, until the trunkclosing.B ...FUNCTIONNINGFUNCTIONNING5.4 - PASSIVE ARMINGFUNCTIONNING!!!The system may generate an alarm condition caused by a shock or a shifting ofthe vehicle itself The shock sensor is buil in the alarm and is adjustableIn armed state, if the vehicle is hit or shifted, the sensor included in the alarmsystem will detect this anomaly and generate an alarm.This function allows the user to leave the vehicle sure that the alarm protectionarms itself automaticallyOnce the engine is switched off, the system automatically activates thepassive arming.This will be signalled by two LED flashes and two siren high-tone beeps.After 35 seconds the system will activate steadly, signalling the operation witha single flash of the turn signals, two acoustic signal and the lighting up of theLED (with a steady light).This function ensures some sort of protection against criminals when a theftattempt happens while the vehicle is in use.The function indeed allows to activate the system while stopping the vehiclewith the ignition key switch on and the engine running.With the ignition key switch on, it is possible to activate the anti-hijackingfunction in the following ways:y pressing button #1 on the remote controlBy pressing button #2 on the remote controlBy inserting the electronic key in the receptacleNOTEThe activation of the anti-hijacking function will be signalledby the system with two rapid flashes of theturn signals and a steady LED.Once enabled the anti-hijacking function, the remote controls won't workanymore.