Gemini 810 User Manual
                                                        | |
Contents
| 
05 - LASER STANDBY AND ACTIVE MODESThe ACTIVE/STANDBY keypad selection serves a dual purpose. It activates (ACTIVE) and deactivatesthe laser (STANDBY). By default, the system powers up in Standby mode. The laser cannot be activatedprior to selecting a wavelength. Each time the ACTIVE/STANDBY selection is touched, the system togglesbetween Active and Standby modes. There is an audio confirmation (unless voice confirmation ismuted), and an icon for either “ACTIVE” or “STANDBY” is displayed near each wavelength indicator.The red aiming beam and tip illumination are visible only when the laser is in Active mode.When the system is in Active mode, touching any selection other than UP and DOWN or LEFT andRIGHT will return the system to the Standby mode. When the activation pedal is depressed in theActive mode, the outer indicator ring around each wavelength icon on the display flashes to providea visual indication that the laser is firing. There is also an audio beep when laser is being fired. Forsafety purposes, a laser firing delay of 0.25 seconds was implemented in order to prevent accidentalactivation.WAVELENGTH - ACTIVE MODESYSTEM IN ACTIVE MODE“810 ACTIVE”“980 ACTIVE”“DUALWAVELENGTHACTIVE”“810 STANDBY”“980 STANDBY”“DUALWAVELENGTHSTANDBY”WAVELENGTH - STANDBY MODESYSTEM IN STANDBY MODENote: Outer rings flash when laser is firing.CONTROLS, OPERATION & USE18 |
Related manuals for Gemini 810
manualsdatabase
Your AI-powered manual search engine