Gemini CDM-3610 Operation Manual

Contents

Congratulations on purchasing the Gemini CDM-3610Professional CD/MP3 DJ Work Station. This unit isbacked by a (1) year warranty. Prior to use, we urge thatyou understand all instructions and features.Player Section--Audio CD, & CD-R, & MP3 compatible-Anti-shock using RAM buffer memory-Large blue backlit LCD display with text for MP3-3 Selectable Jog modes Scratch Effect/Cue Search/Pitch Bend-Instant-start & cue with preview-Instant reverse for added effect-Brake mode for vinyl-like stops-Fader-Start capability-High-speed search using SEARCH buttons-Single & Continuous play modes-One seamless loop per side with reloop-Pitch bend via jog wheel or buttons +/- 16%-Three mode-time selection-Frame accurate search-Rubber jog wheels with finger grips-Variable pitch control with three settings +/- 4, 8 & 16%- Fully programmable with repeat functionMixer Section--3-band EQ w/ Gain Control-1/4” headphone output-XLR and 1/4” mic input-Auxiliary Inputs for Phono or Line devicesLaser Diode PropertiesMaterial: Ga - Al - AsWavelength: 755 - 815 nm (25° C)Laser Output: Continuous Wave, max. 0.5 mW1. Do not use this CD player at temperatures below41°F/5°C or higher than 95°F/35°C.2. The apparatus should not be exposed to dripping orsplashing, and no objects filled with liquids such as vas-es should be placed on the apparatus.3. Place the unit in a clean and dry location.4. Do not place the unit in an unstable location.5. When disconnecting the power cord from the AC out-let, always grasp by the plug. Never pull the power cord.6. To prevent electric shock, do not remove the cover orthe bottom screws.7. There are NO USER SERVICEABLE PARTS INSIDE.Please refer to a qualified technician.(IN THE USA ~ IF YOU EXPERIENCE PROBLEMS WITHTHIS UNIT CALL GEMINI CUSTOMER SERVICE AT: 1(732) 346-0061. DO NOT ATTEMPT TO RETURN THISEQUIPMENT TO YOUR DEALER.)8. Do not use chemical solvents to clean the unit.9. Keep the laser pickup clean by keeping the tray closed.10. Keep this manual in a safe place for future reference.POWER: Plug in the power cord of the CDM-3610.CONVERTIBLE PHONO/LINE INPUTS: The CDM-3610 has2 CONVERTIBLE PHONO/LINE RCA INPUTS whenswitched to the PHONO position (see below) you mayuse any Turntable with a magnetic cartridge, rememberto connect your ground wire (see GROUNDING SCREW)or there may be a system hum. When the switch is in theLINE position you may connect any line level device asdescribed before (MP3, CD, Tape etc). Now you may plugthe RCA’s from your playable medium into each input to beconnected to their respective CHANNELS.NOTE: CONNECTING A LINE LEVEL DEVICE TO A PH IN-PUT MAY CAUSE THAT MIXER CHANNEL TO OVERLOADAND OR DISTORT.CONVERTIBLE LINE SWITCHES: These small switches al-low you to choose between a PHONO (Turntable) input ora LINE level (MP3, CD, Tape player etc..).and require theproper switching.MASTER RCA OUTPUT (UNBALANCED): The MASTERRCA output connects the mixer to your main amplifier us-ing standard audio cables with RCA-type connectors.RECORD RCA OUTPUT: RCA output jacks can be usedto connect the mixer to the record input of your record-ing unit, thus enabling you to record your mix with RCAcables.MASTER XLR OUTPUT (BALANCED): Allows you to con-nect balanced XLR cables to MASTER OUTPUT of theCDM-3610 both the RCA and XLR outputs can be used atthe same time but are both controlled via the same MAS-TER OUTPUT.HEADPHONE OUTPUTS: The HEADPHONE OUTPUTS lo-cated at rear center and front center of the CDM-3610 willaccept any headphone with a standard 1/4” connector andor adaptor and will allow you to CUE your music programbefore you play it. Volume adjustment and PGM mix of theHEADPHONE (see CONTROLS) below.MIC (MICROPHONE) INPUTS: The main MIC or Micro-phone inputs are located at the back right-hand cornerand front panel of the CDM-3610 and will accept any bal-anced and unbalanced XLR as well a standard 1/4” con-nector. Gain control for the mic (See CONTROLS) below.INTRODUCTION:FEATURES:SAFETY SPECIFICATIONS:PRECAUTIONS:CONNECTIONS:8CDM-361021345674