Gemini CDM-3610 Operation Manual

Contents

from end to end can be purchased from your local GEM-INI dealer.NOTE: WHEN USING THE CROSS FADER LIGHTLY GLIDETHE FADER BACK AND FORTH. PRESSING DOWN ONTHE CONTROLS CAN BEND CONTACTS AND CAUSE ALOSS OF SOUND.1. UNSCREW THE FADER SCREWS. DO NOT TOUCH IN-SIDE SCREWS CAREFULLY REMOVE OLD CROSS FAD-ER AND UNPLUG CABLE.2. PLUG IN THE NEW CROSS FADER INTO CABLE ANDPLACE BACK INTO MIXER.3. SCREW THE CROSS FADER TO MIXER WITH THEFADER PLATE SCREWS4. REPLACE THE FACE OF THE MIXER AND SCREW THEFOUR SCREWS BACK IN AND REPLACE THE FADERKNOBS.- If a disc will not play, check to see if the disc was loadedcorrectly (label side up). Also check the disc for exces-sive dirt, scratches, etc.- If the disc turns but there is no sound, check the cableconnections, if they are ok, check your amplifier or re-ceiver.- If the CD skips, check the CD for dirt or scratches. Donot assume that the CD player is defective. Many CD’sare recorded out of spec and will skip on most or all CDplayers. Before sending the unit for repair, try playing aCD that you are sure plays properly.GENERAL:Type................................................................Compact Disc PlayerDisc Type.......................Standard Compact discs (12 cm & 8 cm)Time Display.........Track Elapsed, Track Remain, or Total remainVariable Pitch...........................± 16% Slider with Resume SwitchPitch Bend............................................................± 16% MaximumInstant Start....................................................Within 0.03 secondsInstallation..........................................................................19” eachDimensions..................... 19” x 4.3” x 10.2” (482 x 110 x 260 mm)Weight.................................................Main unit: 12.13 lbs. (5.5 kg)AUDIO SECTION:Quantization..........................1 Bit Linear/Channel, 3 Beam LaserOversampling Rate..............................................................8 TimesSampling Frequency..........................................................44.1 kHzFrequency Response.............................................20 Hz to 20 kHzTotal Harmonic Distortion...................................Less Than 0.05%Signal to Noise Ratio..............................................................85 dBDynamic Range.......................................................................85 dBChannel Separation...................................................85 dB (1 KHz)Output Level.......................................................2.0 +/- 0.2V R.M.S.Power Supply.................................................AC 115/230V, 60/50 HzINPUTS:Phono............................................................................3mV,47 KOhmLine.........................................................................150 mV, 27 KOhmMIC.................................................................1.5 mV, 1 KO balancedOUTPUTS:Max........................................................................ 20V Peak-to PeakRec.............................................................................. 225 mV, 5 KOhS P E C I F I C AT I O N S A N D D E S I G N A R E S U B J E C T T O C H A N G EW I T H O U T N O T I C E F O R P U R P O S E O F I M P R O V E M E N T.CDM-3610TROUBLESHOOTING:SPECIFICATIONS:FADER REPLACEMENT:7