Gemini GEM-P800 Using Manual

Also see for GEM-P800: Installation instructions User guide

Contents

Gemini GEM-P800 Using Manual Manual pdf 15 page image

Ambush Code - In the event that youare forced by an intruder to disarm yoursystem, this special code can be used todisarm the system, and simultaneouslysend a silent alarm to Central Station. Ifyour system has the Ambush featureenabled, the code assigned as the User8 code will function as your AmbushCode.Arming / Disarming - Turning thesystem on or off by entering your usercode at the keypad, followed by.Auto Interior Bypass - A feature whichallows the system to recognize when youhave not left the premises and automati-cally bypass any interior zones, deacti-vating devices such as motion sensors,allowing free movement throughout thepremises.Battery - A backup source of power toprovide protection for a limited time inthe event of a power failure.Bypass - the manual or automatic re-moval of one or more protection zonesfrom the system. Press and thenthe zone number to bypass a zone.Central Station - Monitors alarm,emergency and trouble reports from thealarm system and notifies proper authori-ties.Chime - a keypad beep which indicatesthat a door has been opened while thesystem is disarmed.Easy Exit - Allows an occupant to leavethe premises without disarming the sys-tem. Pressing and then while the system is armed will permit exitby removing the protection on the Exit/Entry door for 3 minutes.Exit/Entry Delay - The amount of timeyou are allowed to enter and leave thepremises when the system is armed.Exit/Entry Zone - A zone which willallow you to enter and leave thepremises when the system is armed.Instant Protection - Arming without En-try Delay while remaining on thepremises. (Press while armed)Keypad Sounder - A local warning de-vice at the keypad to alert that Entrydelay has started,System Trouble - A problem has beendetected in the system which may pre-vent it from working properly.TROUBLE will be lit to indicate a sys-tem trouble.User Code - A four digit code which isused to arm and disarm the system fromthe keypad.User 1 Code - A four digit code whichcan be used to program, re-programand erase user codes, as well as armand disarm the system from the keypad.Zone - An area which is protected by asecurity device. Your front door may bedesignated as Zone 1, while the livingroom motion detector may be Zone 2.Refer to the Zone Label on your keypadfor the Zone Identification of your sys-tem.Glossary15Oi219cpage 15Tuesday, September 16, 1997 08:24

/ 16

Related manuals for Gemini GEM-P800