Genie 4560 Operation & Maintenance Manual

Also see for 4560: Operation and maintenance manual

Contents

A Monthly:, Door springs and door hardware.:- Oil door roller,bearings,and hingesusing siliconelubricant or light oil.DortotoperatedooraUtomaticallyor manuallyifspringsIare broken. Contacta GenieFactoryAuthorizedDealerforservice or CallCustomerServiceat IoBO0o35oGENJE. J, BaBnceDoor.- Closedoor.- ReleaseMagnetb CarriageAssemblyfrom RailAssemblyby pulling down on EmergencyReleaseKnob.- Raisedoor manually 3'- 4' and verify that door staysatthat position.SeeCheckStep2 on page 4.When the door is 3'- 4' abovethe ground, the doorshould stay open. Slight movement isacceptable, ifthe door moves too much,contact a Genie FactoryAuthorized Dealerfor service or call CustomerService1-800-35-GENIE.at- ReattachMagneticCarriageAssemblyto RailAssemblybypulling the EmergencyReleaseKnobtoward PowerHead.- Closedoor.Contact ReverseTest.- Perform Adjustment 2 on page 8.! WARNINGIf the door fails to reverseon contact with the boardadjust the CloseForceControlasspecified in Set JmitSwitchesand ForceControtson #age 7. If the Openerstillfails,contact a GenieFactoryAuthorized Dealerfor serviceor callCustomerServiceat loBO0.35.GENJE.B Yearly:Wipe off old excesslubricant from Drive ScrewLubricate Drive Screwwith Genie Lubricant GLU-3tUseONLYGenie Lubricant (GLU-3). Other lubricantsmay damagethe Opener.GLU-3lubricantFCC AND (C CERT(F(EDing interferencethat may causeundesired operation.TROUBLESHOOTING GUIDESafe=T=Beam® System Self=Diagnostic TroubleshootingSource (Red LED) Sensor (Green LED) Possible Problem SolutionON ON Normal operationo Power Head not powered • Check breakers, fuses, plugsOFF OFF o Wiring from Power Head bad o Check wiring for obvious shortsOFF ON . Wiring to Source missing or bad . Check wiringo Power has been interrupted o Remove power and reapply2 BLINKS, Pause o Beam not aligned o Check Source, Sensor alignment(Repeat) ON • Beam obstructed • Check for obstruction• Sensor defective o Contact Customer Service2 BLINKS, Pause • Wire to Sensor missing or bad • Check wiring(Repeat) OFF • Sensor defective • Contact Customer Services BLINKS,Pause • Sensor receiving interference • Determine source of interference(Repeat) ON • Contact Customer Service4 BLINKS, Pause • Source not sending pubes • Contact Customer Service(Repeat) ON o Source defective o Contact Customer Service10 For Help, call 1-800-35-GENmE or visit www.geniecompany.com