Genie Excelerator Manual 

Also see for Excelerator: Manual

Contents

Genie Excelerator Manual  Manual pdf 25 page image

A Monthly:• Door springs and door hardware:– Oil door roller, bearings, and hinges using siliconelubricant or light oil.• Balance Door.– Close door.– Release Magnetic Carriage Assembly from Rail Assemblyby pulling down on Emergency Release Knob.– Raise door manually 3'- 4' and verify that door stays atthat position. See Check Step 2 on page 3.– Reattach Magnetic Carriage Assembly to Rail Assembly:a. Pull the Emergency Release Knob toward Power Head.b. Close door.• Contact Reverse Test.– Perform Installation Step 10 on page 21.B Yearly:• Wipe off old excess lubricant from Drive Screw.• Lubricate Drive Screw with Genie Lubricant (GLU-3)25For Help, call 1-800-35-GENIE or visit www.geniecompany.comINSTALL LIGHT BULBSAND LENSInstallation Step 13:A Install two 60 Watt light bulbs (not included) into LightSockets (Figure 41):• Rough service, 130 Volt bulbs are recommended.B Install Lens into slots in Motor Cover.C Install Genie Emergency Release Kit (GER-2) accessory,if purchased.D Installation is now complete.NOTEWhen the door is 3' - 4' above the ground, the doorshould stay open. Slight movement is acceptable. Ifthe door moves too much, contact a Genie FactoryAuthorized Dealer for service or call Customer Service at1-800-35-GENIE.WARNINGDo not operate door automatically or manually if springsare broken. Contact a Genie Factory Authorized Dealer forservice or call Customer Service at 1-800-35-GENIE.Lens1ASnap Lens Hinges intoslots on back of Motor Cover60 Wattsmaximum Push inLatchestoclose LensFigure 41 Install Lens Cover and Light BulbsTransmitter Compliance StatementMAINTENANCEWARNINGIf the door fails to reverse on contact with the board,adjust the Close Force Control as specified in Set LimitSwitches and Force Controls on page 20. If the Openerstill fails, contact a Genie Factory Authorized Dealer forservice or call Customer Service at 1-800-35-GENIE.NOTEUse ONLY Genie Lubricant (GLU-3). Other lubricantsmay damage the Opener.FCC AND IC CERTIFIEDAll devices comply with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2)this device must accept any interference received, includ-ing interference that may cause undesired operation.Screw Drive GaragePart No. GLU-3Door Opener LubricantGLU-3Lubricant