Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 3Service Manual - First Edition Section 7 - Repair ProceduresPLATFORM CONTROLS1-2Software ConfigurationThe ECM (Electronic Control Module) containsprogramming for all configurations of the GS-1530and GS-1930. The platform controls can beadjusted to a different configuration by changing thecombination of the DIP switch settings. The DIPswitch is located on the circuit board inside theplatform control box.DIP switches have two positions - ON or OFF. Whenreading the DIP switch code in theDIP SwitchCode Chart, the ON and OFF are represented by thenumbers 1 ( ON ) and 0 ( OFF).Select a test area that is firm, leveland free of obstructions.Models before serial number 17408were not adjustable when theywere shipped from the factory. Ifthe ECM (Electronic ControlModule) has been updated torevision "b0" or later, or if themodel's serial number is after17407, you can access therevision level of the ECM by usingthe following procedure:How to Determine the RevisionLevel1 Remove the platform controls from theplatform.2 Turn the key switch to platform control and pullout the Emergency Stop buttons to the ONposition at both the ground and platformcontrols.3 Press and hold the lift enable button and thefunction enable switch. Move the joystickhandle to the UP position to raise the platform.Observe the code shown in the LED displaywindow, located on the battery pack side of themachine.Result: The configuration code of the DIPswitch will appear in the LED display window.4 Press and hold the lift enable button and thefunction enable switch. Move the joystickhandle to the DOWN position to lower theplatform. Observe the code shown in the LEDdisplay window, located on the battery packside of the machine.Result: The software revision level will appearin the LED display window. If revision level "b0"appears in the display window, the procedureunderHow to Set the DIP Switch Codes on thenext page will apply. If revision level "A" isdisplayed, the procedure will not apply.5 Push in the Emergency Stop button to the OFFposition at both the ground and platformcontrols and turn the key switch to the OFFposition.
